ADEMCO Vista-128FB User Manual download pdf (Page 31)

–

Choices for System Operation are:

20 = Arming-Stay 37 = 2 Times Bell Time-out* 52 = Kissoff

21=Arm Away 38 = Chime 54 = Fire Zone Reset

22 = Disarming 39 = Fire Alarm 55 = Disarm + 1 Minute

30 = On Second Off 40 = Bypassing 56 = XX Minutes

(enter XX in field 1*74)

31 = End of Exit Time 41 = AC Power Fail 57 = YY seconds

(enter YY in field 1*75)

32 = Start of Entry Time 42 = System Battery Low 58 = Duress

33 = Any Burglary Alarm 43 = Communication Failure 60 = Audio Alarm Verification**

34 = Code + # + 71 Key Entry 44 = RF Low Battery 61 = Code + # + 67 Key Entry

35 = Code + # + 72 Key Entry 45 = Polling Loop Failure 62 = Bell 2 Time-out*

36 = At Bell Time-out* 51 = RF Receiver Failure 63 = Aux. Relay Time-out*

*Or at disarming, whichever occurs first

**Must be selected for both START and STOP operation

P = PARTITION No.

1-8, 0 = Any

ZONE LISTS FOR OUTPUT DEVICES

– Programmed in the #93 Menu Mode in the Relay Programming

Section. Fill in the required data on the worksheet below and follow the procedure in the installation

instructions as you enter the data during the displays and prompts that appear in sequence.

Note:

Record desired zone numbers below. More or fewer boxes than shown may be needed, since any list

may include

any

all

of system's zone numbers.

Zone List 1

: Started or stopped by zone numbers (enter 00 to end entries).

…etc.

Zone List 2: