Telco Fault (or CHECK and zone 94)
If the telephone line monitor feature has been programmed for your system, this display indicates that the telephone
line has been disconnected or cut. In some systems, this display will be accompanied by a trouble sound from the
keypad and the external sounder may be activated. Contact your service company immediately.
To silence the trouble sound, enter your security code plus OFF.
User Access Codes
Entry and Exit Delays
General Information
Your system has preset time delays, known as exit delay and entry delay. Whenever you arm your system, exit delay
gives you time to leave through the designated exit door without setting off an alarm. Exit delay begins immediately
after entering any arming command, and applies to all modes of arming protection. If programmed, a slow beeping will
sound throughout the exit delay period.
Entry Delays give you time to disarm the system when you re-enter through the designated entrance door. But you
must disarm the system before the entry delay period ends, or an alarm will occur. The keypad beeps during the entry
delay period, reminding you to disarm the system. There are two entry delays (if programmed). The first is for your
primary entrance and the second can be used for a secondary entrance, where a longer delay is required to walk to the
keypad to disarm the system.
You can also arm the system with no entry delay at all by using either INSTANT or MAXIMUM arming modes. These
modes provide greater security while on the premises or while away for extended periods of time.
Exit Alarms
Whenever you arm the system, the exit delay begins. If an entry/exit door or interior zone is faulted when the exit delay
ends (e.g., exit door left open), the system sounds an alarm and starts the entry delay timer. If you disarm the system
before the entry delay ends, the alarm sound stops and the message "CANCELLED ALARM" or "CA" is displayed on the
keypad, along with a zone number indicating the faulted zone. No message is sent to the alarm monitoring company.
To clear the exit alarm condition, the open zone must be made intact; to clear the display, enter your code plus OFF.
If you do not disarm the system before the entry delay ends, and an entry/exit door or interior zone is still open, the
alarm sound continues and an "exit alarm" message is sent to the alarm monitoring company. The message "EXIT
ALARM" or "EA" is displayed on the keypad, along with a zone number indicating the faulted zone. To stop the alarm,
the system must be disarmed (your code plus OFF); to clear the display, enter your code plus OFF a second time.
An Exit Alarm also results if an entry/exit door or interior zone is faulted within two minutes after the end of the exit
delay.
Using Device Commands
Your system may be set up so that certain lights or other devices can be turned on or off by using the device command
from the keypad. Ask your installer if this has been done in your system. If programmed for your system, some devices
may activate automatically upon certain system conditions. In this case, the following commands can be used to
override the device activation. See your installer for a full explanation of this feature.
(79 pages)
(61 pages)
(132 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals