ADEMCO VISTA-50PEN User Manual

Browse online or download User Manual for Security access control systems ADEMCO VISTA-50PEN. 5870API INSTALLATION AND SETUP GUIDE

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
K14379V2 1/10 Rev. A
5
55
5870API
870API870API
870API
Wireless Indoor Asset Protection Device
Wireless Indoor Asset Protection DeviceWireless Indoor Asset Protection Device
Wireless Indoor Asset Protection Device
INSTALLATION AND SETUP GUIDE
QUICK INSTALLATION
Peel here
Step 1. Select Location
Step 2. Select Operating Mode (refer to table 1)
Step 5.
Test System
Step 3. Program Device (refer to Programming Section)
1-3 Seconds
30
O
Painting
Jewelry Box
LOOP 3
LOOP 3
LOOP 3
LOOP 2
LOOP 1
4. Press down firmly for 5 sec.
3. Rotate into position
Step 4. Install Device
Paintings
Computers
Gun Case/Safe
Large Screen
TV
2. Enter Zone Number, Zone Type,
Input Type at Keypad
Enroll Serial Number
(press tamper switch)
Enter Loop Number at Keypad
(use Loop 2 unless Fast Trigger
or Tilt is required)
30
O
MOUNT HORIZONTALLY ONLY (LOOP 3 ONLY)
NORMAL
FAULT
30
O
OR
Jewelry
Box
Avoid sources of vibration (i.e. speakers,
fans, motors)
Choose a stable, clean, flat surface
Mount in an inconspicuous area.
2. Peel tape backing before
installing. Place onto asset.
High Security (Fast Trigger) Mode (Loop 1)
Standard Security Mode (Loop 2)
Tilt Mode (Loop 3)
5-8 Seconds
Large Screen
TV
(Asset)
Mounting
Surface
PULL TO CONNECT BATTERY
Pull tab
TAB
SENSOR
Greater than 30
O
1. Clean mounting surface
(refer to mounting notes)
Valuables
LOOP 1 is for High Security (Fast Trigger) applications and should ONLY be used if the asset will NOT
be subject to external vibration. Loop 2 (Standard Security mode) should be used in most cases.
1. Pull tab to activate battery
Page view 0
1 2 3 4

Summary of Contents

Page 1 - QUICK INSTALLATION

K14379V2 1/10 Rev. A 5555870API870API870API870API Wireless Indoor Asset Protection DeviceWireless Indoor Asset Protection DeviceWireless Indoor

Page 2

- 2 - GENERAL INFORMATION 5870API is a wireless, supervised asset protection device that is compatible with systems that support 5800 series de

Page 3 - 1.7"

- 3 - REPLACING THE BATTERY 5870API is powered by a 3-volt lithium battery. If the battery voltage gets too low, the device sends a low battery si

Page 4 - ÊK14379V2jŠ

UL APPROVED COMPATIBLE CONTROL PANELS The 5870API is compatible with the following commercial control panel families: Vista-10P/10PCN/10PSIA, Vista-1

Comments to this Manuals

No comments