ADEMCO 5110XM Setup Guide download pdf (Page 34)

5110XM Installation and Setup Guide

5-4

Adding Custom Words

You can add up to five installer-defined words to the built-in vocabulary. Each of the five "words" can actually consist of

a "word string" of one or more words, but no more than ten characters can be used for each word or word string.

Custom words must begin with an alphabetic character. If a number or symbol is used as the first

character, the word will not be saved.

Enter the programming mode, press 82 and then press 1. The CUSTOM WORD ? is displayed

Press 1 to select the CUSTOM WORD mode (enter “1”) when the prompt CUSTOM WORD ? is displayed.

When adding Custom Words, the keypad keys perform the following functions:

[3] Advances through the alphabet in ascending order.

[1] Moves through the alphabet in descending order.

[6] Selects desired letter; moves cursor one space to right.

[4] Moves cursor one space to left.

[7] Inserts a space at the cursor location, erasing any character located there.

[8] Saves the new word in the system's memory.

Enter the number ([1]–[5]) of the custom word or word string to be created (for example, if you are creating the first

custom word or word-string, enter [1], for the second, enter [2], etc.). A cursor will now appear at the beginning of the

second line.

One of two methods of entering the custom word's characters can now be used (refer to the CHARACTER LIST

of letters, numbers, and symbols on a following page):

Method 1:

Press the [#] key, followed by the two-digit entry for the first letter you would like to display (e.g., [6][5] for "A"), or...

Method 2:

Use the [3] key to advance through the list of symbols, numbers, and letters. Use the [1] key to move back through the

list.

When you have reached the desired character, press [6] to select it. The cursor will then move to the right, in position

for the next character.

Repeat the previous steps to create the desired word(s). Note, that the [4] key can be used to move the cursor to the left,

if necessary, and that key [7] can be used to enter a blank (or erase an existing character). Remember, no word or word-

string can exceed 10 characters.

Press the [8] key to save the custom word(s) and return to the "CUSTOM WORD?" display.

Repeat the steps for other custom words to be entered. To change a custom word, just overwrite it. If no more are to be

entered now, press [0] to return to the Descriptor entry. The custom word(s) will be automatically added to the built-in

vocabulary.

When zone descriptors are being programmed for the zones, the custom word numbers are 250 to 254 for words 1 to 5,

respectively.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 63 64

No comments

ADEMCO 5110XM Setup Guide Page 34