ADEMCO VISTA 10 User's Guide download pdf (Page 20)

– 20 –

Bypassing Protection Zones

Using the BYPASS Key

Use this key when you want to arm your system with one or more zones intentionally

unprotected.

Vent Zones: Your system may have certain windows set as “vent” zones, which are

automatically bypassed if left open when arming the system (you do not need to

manually bypass them). However, if a vent zone window is closed after arming, it

becomes protected and will cause an alarm if opened again while the system is armed.

When bypassing zones:

• The system must be disarmed before you can bypass zones.

• Bypassed zones are unprotected and will not cause an alarm if violated.

• The system will not allow fire zones to be bypassed.

• Zones are automatically unbypassed when the system is disarmed.

+ 6 + zone numbers (see below)

(Security Code) BYPASS

Enter the 2-digit zone number(s) for the zone(s) to be

bypassed (e.g., 06, 10, 13, etc.). Single digit zone

numbers must be preceded by a zero (e.g. 05, 06).

Alpha Display:

DISARMED - PRESS

* TO SHOW FAULTS

Fixed-Word Display: NOT READY

2. When finished, the keypad will momentarily display

a "Bypass" message for each bypassed zone number.

Wait for all bypassed zones to be displayed.

Arm the system as usual. When armed, the arming

message is displayed with “ZONE BYPASSED.”

To display bypassed zones prior to arming, enter

your security code and press the [6] BYPASS key.

Alpha Display:

DISARMED BYPASS

READY TO ARM

Fixed-Word Display: BYPASS

ARMED: STAY

ZONE BYPASSED

Typical armed alpha display after

bypassing zones.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

No comments

ADEMCO VISTA 10 User's Guide Page 20