ADEMCO VISTA-250FBP User's Guide download pdf (Page 39)

– 39 –

Disarming and Silencing Alarms

Using the 1 OFF Key

The OFF key is used to disarm the system and to silence alarm and trouble

sounds. See Summary of Audible Notification section for information that

will help you to distinguish between FIRE and BURGLARY alarm sounds.

IMPORTANT: If you return and the main burglary sounder is on, DO NOT enter

the premises, but call the police from a nearby safe location. If you return after an

alarm has occurred and the main sounder has shut itself off, the keypad will beep

rapidly upon entering, indicating that an alarm has occurred during your absence.

LEAVE the premises IMMEDIATELY and CONTACT THE POLICE from a

nearby safe location.

To disarm the system and silence burglary or fire alarms:

OFF

1. Enter your security code and press 1 .

DISARMED

READY TO ARM

2. The Ready message will be displayed (if no alarms have occurred while

armed) and the keypad will beep once to confirm that the system is

disarmed.

Memory of Alarm

The keypad displays the zone number and type of alarm for any zone that

has an alarm condition. These messages will remain displayed until cleared

by a user. If an alarm has occurred, note the zone number displayed on the

keypad and repeat step 1 above to clear the "Memory of Alarm" and restore

the Ready message display. If the Ready message will not display, go to the

displayed zone and remedy the fault (close windows, etc.). If the fault cannot

be remedied, notify the alarm agency.

If the system was armed when the alarm occurred, repeat step 1 twice: once

to disarm the system, a second time to clear the display.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 79 80

No comments

ADEMCO VISTA-250FBP User's Guide Page 39