ADEMCO Vista-128FB User Manual download pdf (Page 44)

—

44 —

Custom Word Substitutes for VIP Module Annunciation

A substitute word can be programmed for each of the 20 custom words used in your alpha zone descriptions.

The VIP Module will announce this substitute word in place of the custom word that is displayed on the

alpha keypad. For example, an alarm display of "John's Bedroom" could be announced as "Son's Bedroom,"

since there is no annunciation for the custom word "John." Note that if a substitute word is not assigned, the

VIP Module will not annunciate the zone descriptor at all, but will only annunciate the zone number.

To enter custom word substitutes, do the following:

From Data Field Programming Mode, press #93 to display the "ZONE PROG?" prompt.

Press 0 (NO) to each menu option until the "CUSTOM INDEX ?" prompt is displayed.

CUSTOM INDEX ?

0=no 1=yes

Enter 1 at this prompt.

CUSTOM WORD NO.

00=QUIT

Enter the custom word number (01-20) for which a voice

substitute is desired. Enter 00 to quit this Programming Mode.

Press [∗] to accept entry.

01 ENTER INDEX #

Enter the 3-digit substitute word index number from the relay

voice descriptor and custom word substitutes vocabulary list

found in the Relay Voice Descriptors part of this section.

Press [∗] to accept entry.

The "CUSTOM WORD NO." prompt will be displayed. Enter

the next custom word number to be substituted or enter 00 to

quit.

RF Serial Number Clear Mode

This mode may be used in the event that an undesired transmitter has been enrolled during sequential

enrolling, causing each subsequent serial number to be assigned to an incorrect zone. Performing this

operation will delete all RF serial numbers, leaving all other zone information intact. You may then return

to Sequential Mode to re-enroll wireless transmitters.

The RF Serial Number Clear Mode will

not

delete polling loop serial numbers.

To clear all RF wireless serial numbers, do the following:

Enter Data Field Programming Mode: [Installer Code] + 8 0 0 0.

From Data Field Programming Mode, press #93 to display the "ZONE PROG?" prompt.

Press 0 (NO) repeatedly until the "CLEAR RF SERIAL #?" prompt appears.

CLEAR RF SERIAL#?

1 = YES, 0 = NO 0

Enter 1 to clear all RF wireless serial numbers. The "ARE

YOU SURE?" prompt is displayed as follows:

ARE YOU SURE?

1 = YES, 0 = NO 0

Enter 1 to clear all RF serial numbers. Re-enter the Sequential

Mode to enroll wireless transmitters.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 67 68

Comments to this Manuals

No comments

ADEMCO Vista-128FB User Manual Page 44

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-128FB