ADEMCO 6270 Setup Guide download pdf (Page 31)

SECTION 5: Setup

5–13

SCREEN ACTION

The "System Setup" screen is displayed.

ECP Address Selection

After enabling addresses in the control panel using an alpha-keypad,

power-up each TouchCenter one at a time, and set its address to one of

the addresses you enabled in the control panel. Otherwise, access the

Central Station screen then follow the procedure to change the address

on the unit.

To change the address, perform the following.

SCREEN ACTION

1. On the “ECP Address” screen, select

the ECP address for this TouchCenter

using the Up/Dn arrows.

2. The available ECP addresses are:

1-2, 5-6 for residential controls or

1-30 for commercial controls

Press the Apply button to accept the

address setting. If the ECP address is

changed, and Apply is selected, the

TouchCenter will reset.

The "CS Setup" menu screen is

displayed.

Options and Operating Modes

The system "Options" menu allows you to enable the Display Lighting

and the EN50131 Display feature.

EN50131 Display

This feature is a European Standard designed to prevent unauthorized

users from knowing the status of the Security System. When the

EN50131 Display feature is turned ON:

• The keypad returns to the "Home" screen after 30 seconds

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 63 64

No comments

ADEMCO 6270 Setup Guide Page 31