ADEMCO VISTA-128B User's Guide download pdf (Page 36)

– 36 –

Arming Perimeter Only

(With Entry Delay ON)

Using the 3 STAY key

Use this key when you are staying home, but might expect someone to use

the entrance door later.

When armed in STAY mode, the system will sound an alarm if a protected

door or window is opened, but you may otherwise move freely throughout the

premises. Late arrivals can enter through the entrance door without causing

an alarm, but they must disarm the system within the entry delay period or

an alarm will occur.

The system provides three STAY modes. STAY mode 1, 2, and 3. STAY

modes 1 and 2, when activated, automatically bypass specific zones assigned

by your installer to each of the STAY modes. STAY mode 3, when activated,

automatically bypasses all zones assigned to STAY modes 1 AND 2. Check

with your installer for a list of the zones that are bypassed during each STAY

mode.

Close all perimeter windows and doors before arming (see

CHECKING FOR OPEN ZONES section)

STAY

1. Enter your security code and press 3 + 1 for STAY Mode 1.

Enter your security code and press 3

+ 2 for STAY Mode 2.

Enter your security code and press 3

+ 3 for STAY Mode 3.

NOTE: If none of the zones in a partition are assigned to Stay mode 2, then

when the user enters [User Code] + [3] (STAY), all zones assigned to Stay

mode 1 are automatically bypassed.

ARMED ***STAY 1*

ZONE BYPASSED

The keypad beeps three times, displays the

armed message, and indicates which STAY

mode (1, 2 or 3).

Note: "ZONE BYPASSED" in this display

simply indicates that some zones of protection

are not armed when using STAY mode.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 79 80

No comments

ADEMCO VISTA-128B User's Guide Page 36