ADEMCO VISTA-128B User's Guide download pdf (Page 61)

– 61 –

Event Log Procedures (continued)

ALARM EVENT LOG

Displays time and date for zones that has

either caused an alarm or has been

restored in the selected partition.

CHECK EVENT LOG

Displays time and date for zones that has

caused a trouble or supervisory condition

in the selected partition.

BYPASS EVENT LOG

Displays time and date for zones that has

been bypassed in the partition.

OPEN EVENT LOG

Displays time, date and user number or 6-

character descriptor for the user, if

programmed, for each arming and

disarming of the system for the partition

selected.

SYSTEM EVENT LOG

Displays time and date for system

problems, such as AC Loss, low battery,

etc., regardless of partition.

ALL EVENT LOG

Displays all categories of events in

chronological order.

See your Installer for additional

information concerning the event log.

Setting the Time and Date

1. Enter Installer or Master Code + [#] +

63. Typical display shows:

TIME/DATE –– THU

12:01 AM 01/01/90

The day of the week is automatically

calculated based on the date entered.

Time and date entries are made by simply

entering the appropriate hour, minute,

month, day and year.

Press [✳] to move the cursor to the right of

the display, to the next position.

Press [#] to move the cursor to the left of

the display, to the previous position.

2. Enter the hour. Then press [✳] to

move to the “minutes” field.

3. Enter the minutes. Press [✳] to move

to the AM/PM position.

4. Press any key 0-9 to change AM to

PM, or PM to AM. Press [✳] to move

cursor to the “month” field position.

5. Enter the month using a 2-digit entry.

Press [✳] to move cursor to the “day”

field position.

6. Enter the day using a 2-digit entry.

Press [✳] to move cursor to the “year”

field position.

7. Press [✳] to continue.

8. The following display appears:

Broadcast Time?

1=YES 0=NO 0

If panel linking is being used, enter 1

(YES) to send this time and date setting to

all the other panels. Otherwise enter 0.

Press [✳] to exit the real-time clock edit

mode.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 79 80

Comments to this Manuals

No comments