ADEMCO Vista User Manual download pdf (Page 16)

–16–

ARMING PERIMETER ONLY

WITH ENTRY DELAY ON

Using the

3 STAY Key

BEFORE ARMING,

close all doors and windows

(see

CHECKING

FOR

OPEN

ZONES

on page 13).

THE STAY MODE ARMS

THE PERIMETER, BUT

ALLOWS USE OF THE

ENTRY/EXIT DOOR.

PERSONS WITHIN THE

PREMISES CAN MOVE

ABOUT FREELY.

Use this key when staying inside, but expect someone to use an entry/exit door later.

1. Enter your security code and press the STAY key.

2. The keypad beeps three times and displays the armed STAY message. The red

ARMED indicator lights. Note that there is an

exit

delay in effect before arming actually

takes place. See the note below.

3. After arming, an alarm sounds immediately if a protected perimeter window or non-

entry/exit door is then opened, but you may otherwise move freely throughout the

premises.

Anyone entering later can enter through an entry/exit door without causing an alarm, but

they must disarm the system within the

entry

delay period to avoid sounding an alarm.

If you wish to open the entry/exit door to let someone in after arming STAY, you can re-

start the

exit

delay at any time – simply press the [✱ ] key, and then let that person in.

This will avoid having to disarm the system and then re-arm it again.

Note: When you first arm the system in the STAY mode, “You may exit now” will be

displayed on the second line of an Alpha keypad during the programmed exit

delay.

This delay is in effect in the system even when arming STAY.

When the

exit delay period ends, the system is fully armed in the STAY mode.

TYPICAL DISPLAYS – “ARMED STAY”

STAY

ARMED

***

STAY

***

YOU MAY EXIT NOW

FIXED-WORD

The message “you may exit now”

> ALPHA

disappears when the exit delay expires.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Comments to this Manuals

No comments

ADEMCO Vista User Manual Page 16

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista