ADEMCO Vista-128FB User Manual download pdf (Page 24)

–

010 CONFIRMED SL:1

A022-4064

When the system sees activity on the appropriate input, it will beep

three times and display the confirmation message. Press

[∗]

the upper left-hand button of the program tool when you are ready

to enroll the next serial number device.

At any time during this step, you may press

[∗]

on the keypad or the upper left-hand button of the

program tool if you are satisfied with the serial and loop number combination that has been

enrolled, regardless of whether or not the enrolled input has been "confirmed." This will ready the

system to enroll the next serial number device.

If the incorrect device has been enrolled, press [#] on the keypad or the upper right-hand button of

the program tool to delete the serial number and return to the "LEARN S/N?" prompt. A single long

beep will be heard from the keypad to verify pressing of the upper right-hand button. Then, press

(Yes) or press the upper left-hand button of the program tool (a single short beep will verify the

system is ready for enrolling) and re-activate the proper device or device loop input.

The system will search for the next zone that does not have a serial number associated with it. If one is

found, the system will return to the “INPUT S/N” prompt for the remaining zones.

After all zones have been displayed, whether enrolled or not, the "ENTER ZN NO." prompt will appear.

Enter 000 to exit the Sequential Mode and return to Data Field Programming Mode.

When you have finished programming all zones, test each using the system's Test Mode. Do not

use the Transmitter ID Sniffer Mode for this, as it will only check for transmission of one zone on a

particular transmitter, NOT the zones assigned to each additional loop, and will NOT verify polling

loop type.

Report Code Programming

All report codes are entered using #93 Menu Mode Programming, either through Report Code Programming,

or through the Zone Programming while entering other zone information. In the VISTA-128FB, reports are

divided into six categories. These categories represent the main menu options found in the Report Code

Programming. Reports and the categories in which they are found are as follows:

ALARM CODES RESTR, SUPV. CODES

(for groups of 16 zones)

SYSTEM GROUP #1

Zone Alarm Reports Alarm Restore

Trouble

Trouble Restore

Bypass

Bypass Restore

Closing (arm away)

Opening (disarm)

System Low Battery

Low Battery Restore

AC Loss

AC Restore

Periodic Test

Power

Cancel

Program Tamper

SYSTEM GROUP #2 SYSTEM GROUP #3 SYSTEM GROUP #4

Arm STAY

Time Set, Log Reset

Log 50%, 90% Full

Event Log Overflow

Exit Error by Zone

Exit Error by User

Recent Close

Early Open

Early Close

Late Open

Late Close

Failed to Open

Failed to Close

Auto-Arm Failed

Schedule Change

Fire Walk Test Start

Fire Walk Test End

Off-Normal

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Comments to this Manuals

No comments

ADEMCO Vista-128FB User Manual Page 24

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-128FB