ADEMCO VISTA 10 User's Guide download pdf (Page 13)

– 13 –

ENTRY / EXIT DELAYS

General Information

Your system has preset time delays, known as Exit Delay and Entry Delay.

When you arm your system, Exit Delay gives you time to leave through the

entry/exit door without setting off an alarm. Entry Delay gives you time to

disarm the system when you re-enter through the entry/exit door. The system

must be disarmed, however, before the entry delay period ends, or an alarm

will occur. The keypad will beep slowly during the entry delay period,

reminding you to disarm the system.

You can also arm the system with no entry delay at all by using either

INSTANT or MAXIMUM arming modes. These modes can provide greater

security while you are sleeping or while you are away for extended periods of

time. Remember, there will be NO entry delay when arming INSTANT or

MAXIMUM.

See your installer for your programmed delay times and record them here:

Exit Delay:

seconds

Entry Delay:

seconds

Exit Delay Alerting Sound

Ask your installer if this feature is active for your system, and if so, check

here:

When arming the system AWAY (see page 20) or MAXIMUM (see page 21),

slow warning tones will sound from the keypad(s) during the exit delay,

turning to fast tones during the final five seconds of the exit delay time.

Exit Delay Restart

Check here if active:

Your system may have been programmed to allow you to restart the exit

delay after the system has been armed in STAY mode. This is useful if you

wish to open the entry/exit door to let someone in after arming the system,

and avoids having to disarm the system and then rearm it again. If

programmed, you can restart the exit delay by pressing the

[

✴

]

key. Ask your

installer if this feature is active for your system. If so, check box above.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

No comments

ADEMCO VISTA 10 User's Guide Page 13