ADEMCO VISTA 10 User's Guide download pdf (Page 16)

– 16 –

ARMING PERIMETER ONLY

With Entry Delay ON

Using the 3 STAY Key

BEFORE ARMING, make sure all non-main doors and windows are closed.

Refer to CHECKING FOR OPEN ZONES on page 18.

Use this key when you are staying inside, but you expect someone to use an

entry/exit door later.

1. Enter your security code and press the STAY key.

2. The keypad will beep three times and display the armed STAY message.

The red ARMED indicator will light. Note that there is an exit delay in

effect before arming actually takes place. See the note below.

3. After arming, an alarm will sound immediately if a protected perimeter

window or non-entry/exit door is opened, but you may otherwise move

freely throughout the premises.

Anyone can enter later through an entry/exit door without causing an alarm,

but they must disarm the system within the entry delay period to avoid

sounding an alarm.

If you wish to open the entry/exit door to let someone in after arming STAY,

you can re-start the exit delay at any time – simply press the [

✴

] key, and

then let that person in. This will avoid having to disarm the system and then

re-arm it again.

Note: When you first arm the system in the STAY mode, “YOU MAY EXIT

NOW” will be displayed on an alpha keypad during the programmed

exit delay. This delay is in effect in the system even when arming

STAY. When the exit delay period ends, “YOU MAY EXIT NOW”

disappears and the system is then fully armed in the STAY mode.

THE

STAY MODE

ARMS THE PERIMETER, BUT ALLOWS USE OF THE ENTRY/EXIT

DOOR. PERSONS WITHIN THE PREMISES CAN MOVE ABOUT FREELY.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

No comments

ADEMCO VISTA 10 User's Guide Page 16