ADEMCO VISTA-20HWse Troubleshooting Guide download pdf (Page 36)

–36–

Section 12. MECHANICS OF PROGRAMMING

This section provides information on how to use the system's programming

modes. It will enable you to understand how to enter and exit programming

mode, and how to program the data fields and how to use the user-friendly

interactive modes (

56,

80,

81,

82).

If wired expansion will be used, the following program field must be

programmed (as required) before doing any zone programming.

25 WIRED ZONE EXPANSION

In addition, the following fields must be programmed before completing the installation.

20 INSTALLER CODE

21 QUICK ARM ENABLE

23 FORCED BYPASS (must be disabled for UL installations, enter Ò0Ó).

General Programming Information

Characteristics for each installation are stored in non-removable, electrically

erasable, non-volatile EEROM memory. These must be programmed for the

particular installation to establish its specific alarm and reporting features.

It is possible to program the system at any time, even at the installer's premises

prior to the actual installation. Simply apply power temporarily to the control and

then program the unit as desired.

IMPORTANT: You cannot enter the programming mode unless both

partitions are disarmed.

There are two programming modes: data field programming and interactive

(menu) mode programming. Data field programming is used for setting various

system options and interactive programming is used for programming zone

information and programming relay outputs.

To program the system, you must use a 5137AD or 6139 2-line Alpha keypad

connected to the Partition 1 keypad terminals on the control (4, 5, 6, & 7). Also,

both partitions must be disarmed. The Alpha keypad need not necessarily

remain in the system after programming.

Programming can also be performed remotely from the installer’s office/home,

using an IBM personal computer, a modem, and V-Link downloading software.

See the

REMOTE PROGRAMMING AND CONTROL (DOWNLOADING)

section

Entering Program Mode

You may use one of the following methods:

a) Press both the [

] and [#] keys at the same time within 50 seconds after

power is applied to the Control, or

b) After power up, enter the Installer code (4 1 1 2) + 8 0 0.

This method is disabled if you exit the program mode using

98 instead of

99.

See “Exiting Program Mode” paragraph later in this section.

If a different Installer code is subsequently programmed, use it instead of 4112

to gain access to the Programming mode.

Following entry into program mode, data field

20 will be displayed (this is the first

data field in the system). The system will now accept entries for field

20.

Programming a Data Field

1. Press [

] plus Field No. (for example,

21), then make the required entry.

2. When you have completely programmed a data field, the keypad will “beep”

three times and then automatically display the next data field in sequence. To

go to a different field, press [

] plus the desired field No.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 83 84

Comments to this Manuals

No comments

ADEMCO VISTA-20HWse Troubleshooting Guide Page 36

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA-20HWse