ADEMCO VISTA-20HWse Troubleshooting Guide download pdf (Page 37)

–

7–

3. If the number of digits that you need to enter in a data field is less than the

maximum digits available (for example, the phone number field), enter the

desired data, then press [

and the next data field number to be programmed.

4. If you try to enter a non-existent field, the keypad will display EE or Entry

Error. Simply re-enter [

] plus a valid field number.

Reviewing a Data Field/Erasing an Entry in a Data Field

Press [#] plus Field No. Data will be displayed for that field number. No

changes will be accepted in this mode.

To delete an entry in a field, press [

] plus Field No. + [

]. (Applies only to fields

40–

46, and

94).

Interactive Mode Programming (

56,

80,

81, and

82)

Typical prompt displayed

during interactive mode

programming

Enter Zn Num.

(00 = Quit) 01

Zone Number -

Press [

] plus interactive mode no. (for example,

56). The Alpha keypad will

display the first of a series of prompts requesting entries.

A detailed procedure (with displays of prompts) is provided in later sections of

this manual.

Interactive Mode Used To Program

56 Zone Programming Zone characteristics, report codes and alpha

descriptors

80 Relay Programming 4229 or 4204 Relay modules, or Powerline

Carrier devices

81 Zone List Programming Zone Lists for relay/powerline carrier activation

82 Alpha Programming Zone alpha descriptors

Loading Factory Defaults

To load the factory defaults, enter the programming mode, press

97, then exit

the programming mode.

Do not press

97 to load defaults if any programming has been done

previously—data already programmed into the system will be changed!

96 resets all the Subscriber Account numbers and CSID in preparation for an

initial download.

Programming System Setup Fields

The following program field must be programmed before doing any zone

programming.

25 WIRED ZONE EXPANSION 0

Use this field to select the type of expansion unit being used, as follows:

0 = none; 1 = 4219; 2 = 4229; 3 = 4204. Default is 0.

Exiting the Programming Mode

99 allows re-entry into the program mode using Installer Code + 8 0 0.

98 inhibits re-entry into the programming mode using the Installer code.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 83 84

Comments to this Manuals

No comments

ADEMCO VISTA-20HWse Troubleshooting Guide Page 37

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA-20HWse