ADEMCO VISTA-250FBP Setup Guide download pdf (Page 16)

– 16 –

Programming With #93 Menu Mode

NOTE: The following field should be preset before beginning: 2*00 Number of Partitions. In addition, receivers should

be programmed via Device programming.

After programming all system related programming fields in the usual way, press #93 while still in programming mode to

display the first choice of the menu driven programming functions. Press 0 (NO) or 1 (YES) in response to the displayed menu

selection. Pressing 0 will display the next choice in sequence.

NOTE: All references in this manual for number of zones, number of user codes, number of access cards, and the

event log capacity, use the VISTA-250FBP’s features. See page 5 of this manual for the table listing the differences

between the VISTA-128FBP and the VISTA-250FBP control panels.

#93 MENU MODE KEY COMMANDS

The following is a list of commands used while in the menu mode.

#93 Enters Menu mode

[✱] Serves as ENTER key. Press to have keypad accept entry.

[#] Backs up to previous screen.

0 Press to answer NO

1 Press to answer YES

001-009 All data entries are either 2-digit or 3-digit entries.

000 Exits menu mode, back into field programming mode, when entered at the first question for each category.

Menu selections are as follows:

PROMPT

EXPLANATION

ZONE PROG?

1 = YES 0 = NO 0

For programming the following:

• Zone Number

• Zone Response Type

• Partition Number for Zone

• Dialer report code for zone

• Input Device Type for zone (whether RF, polling loop, etc.)

• Enrolling serial numbers of 5800 Series transmitters & serial polling loop devices into the system.

• Zone Attributes (e.g., Arm w/Fault, Silent, etc.)

EXPERT MODE?

1 = YES 0 = NO 0

Same as Zone Programming except:

• Done with a minimum number of keystrokes.

• Can program wireless keys using pre-defined templates.

NOTE: Be aware some of the zone attributes cannot be programmed in the Expert Mode. These can only be

done in Zone Programming.

REPORT CODE PROG?

1 = YES 0 = NO 0

For programming the following:

• Alarm report codes for zones

• Restore & supervisory codes

• All other system report codes

ALPHA PROG?

1 = YES 0 = NO 0

For entering alpha descriptors for the following:

• Zone Descriptors

• Default Screen

• Custom Words

• Partition Descriptors

DEVICE PROG?

1 = YES 0 = NO 0

For defining the following device characteristics for addressable devices, including keypads, RF receivers

(5881), output relay modules (4204/4204CF), and Communicators (7845i-ent).

• Device Address

• Device Type

• Keypad Options (incl. partition assignment)

• RF House ID

• Communicator Options (incl. programming communicators)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 71 72

Comments to this Manuals

No comments

ADEMCO VISTA-250FBP Setup Guide Page 16

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA-250FBP