ADEMCO VISTA-250FBP Setup Guide download pdf (Page 17)

– 17 –

PROMPT

EXPLANATION

OUTPUT PGM?

1 = YES 0 = NO 0

For defining output relay functions.

RLY VOICE DESCR?

1 = YES 0 = NO 0

Not Used. Must be set to “0”.

CUSTOM INDEX?

1 = YES 0 = NO 0

Not Used. Must be set to “0”.

ACCESS POINT PGM

1 = YES 0 = NO 0

Not Used. Must be set to “0”.

ACCESS GRP PGM

1 = YES 0 = NO 0

Not Used. Must be set to “0”.

EVENT/ACTION PGM

1 = YES 0 = NO 0

Not Used. Must be set to “0”.

SCHEDULED CHK-IN

1 = YES 0 = NO 0

For defining the schedule for the system to automatically call the downloader.

NOTE: Must be set to “0” for Commercial Fire installations.

Zone Programming

• All Fire zones should be assigned to partition 1.

• If using 5800 Series transmitters, do not the install batteries until you are ready to enroll them. After

enrolling the transmitter, the battery need not be removed. This is to prevent enrolling the wrong serial

number.

PROMPT

EXPLANATION

ZONE PROG?

1 = YES 0 = NO 0

Press 1 to enter ZONE PROGRAMMING mode. The following screens appear. Press [✱] to display the next

screen. Press # to display a previous screen.

SET TO CONFIRM?

1 = YES 0 = NO 0

This prompt appears once upon entering Zone Programming Mode.

If “Yes,” Confirmation prompts will be displayed after the device’s Serial and Loop numbers have been

entered later.

ENTER ZONE NO.

000 = QUIT 010

Zone 010 entered

↑

Enter the 3-digit zone number to be programmed, as follows:

Protection Zones = 001–250

Relay Zones = 601–632 (use for relays on 4204CF modules only).

ECP Device Supervisory Zones = 800–830

System Supervisory Zones = 988, 990, 992 (duress), 997

Keypad Panic Zones = 995 (Do not use in Fire Alarm applications), 996, 999

Press [✱] to continue.

010 ZT P RC In L

00 1 10 00 1

This display appears, showing a summary of the zone's current programming. ZT = Zone Type, P =

Partition, RC = Report Code, In = the input type of device, and L = the device's loop number to which the

sensor is connected.

Some devices can support more than one zone by means of individual loops (for example 5817CB, etc.). If

the zone is not programmed, the display appears as shown here. If you are checking a zone's programming,

and it is programmed satisfactorily, press [#] to back up one step and enter another zone number, if desired.

Press [✱] to continue.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 71 72

Comments to this Manuals

No comments

ADEMCO VISTA-250FBP Setup Guide Page 17

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA-250FBP