ADEMCO Symphony 8142 Setup Guide download pdf (Page 61)

Menu Mode Programming

5-5

PROMPT

VALID ENTRIES EXPLANATION

XMIT TO CONFIRM

PRESS ✱ TO SKIP

Confirmation Option

Activate the loop input or button

[∗] to continue

This prompt will only appear if you answered

“Yes” at the first prompt in this section.

The system will enter a confirmation mode so that

the operation of the actual programmed input can

be confirmed.

Activate the loop input or button that corresponds

to this zone.

If the serial number and/or loop number

transmitted does not match the serial number

entered, a display similar to the one below appears.

Entd A022-4063 1

Rcvd A022-4064 1

If so, activate the loop input or button on the

transmitter once again. If a match is not obtained

(i.e., summary display does not appear), press the

[#] key twice and then enter (or transmit) the

correct serial number.

Press [∗] to continue.

Zn ZT RC In: L

17 03 10 RF: 1s

Summary Screen

[∗] to continue

If the serial number transmitted matches

the serial number entered, the keypad will

beep 3 times and a summary display will

appear, showing that zone's programming.

Note that an “s” indicates that a

transmitter’s serial number has been

enrolled.

Press [∗] to accept the zone information and

continue.

PROGRAM ALPHA?

0 = NO 1 = YES 0

Alpha Descriptors

0 = no

1 = yes

[∗] to continue

If you want to program descriptors for zones now,

enter 1 (Yes) and refer to the Alpha Descriptor

Programming section for the procedure to use.

ENTER ZN NUM.

(00 = QUIT) 11

Next Zone Number

00 = quit

[∗] to continue

If 0 (No) was entered above, the system will

return you to the ENTER ZN NUM. prompt for

the next zone.

When all zones have been programmed, enter 00

to quit.

Completing Zone Programming

When you have finished programming all zones, test each zone using the system’s TEST mode. Do not

use the Sensor Sniffer Mode for checking wireless transmitting devices, as it will only check for

transmission of one zone on a particular transmitter, NOT the zones assigned to each additional loop.

NOTE: Following the successful enrollment of each wireless device, note the device serial number in

the appropriate column on the ENROLLED TRANSMITTERS worksheet in the Programming Form;

then enter the other information (zone number, zone type, loop number, etc.) relevant to that device.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 111 112

Comments to this Manuals

No comments

ADEMCO Symphony 8142 Setup Guide Page 61

Comments to this Manuals

Related products and manuals for Numeric keypads ADEMCO Symphony 8142