ADEMCO Symphony 8142 Setup Guide download pdf (Page 79)

Testing the System

5-23

PROMPT

VALID ENTRIES EXPLANATION

90 TRBL SOUND

Trouble Sounding

0= none

1= one beep every minute

2= normal trouble sound (fast

beeps)

[∗] to continue

Select type of sounding upon trouble conditions on

zones assigned to this zone type.

90 ALARM SOUND

Alarm Sounding

0=none

1= keypad sound only

2= steady siren sounding

3= pulsing siren (temporal)

[∗] to continue

Select type of sounding upon alarm conditions on

zones assigned to this zone type.

90 Dial Delay

0=No, 1=Yes

Dial Delay?

0=no

1=yes

[∗] to continue

If selected, faults on zones assigned to this zone

type will delay reporting for whatever length of

time that is selected in dial delay (*50).

90 Disp Option

Display Options

0 = no display

1 = display only

2 = chime only

3 = chime & disp.

[∗] to continue

Select whether faults on zones assigned to this

zone type are displayed at the keypad and/or

cause a chime sound.

Alarm ID: 000

Trouble ID: 000

Contact ID Report Codes

000-999 = report code

[∗] to continue; returns to Enter

configurable zone type number

prompt.

Enter the desired 3-digit Contact ID report codes

for faults and troubles occurring on zones assigned

to this zone type.

IMPORTANT:

• Make sure the code does not conflict with

existing, predefined Contact ID report codes.

See the System Communication section for a

list of standard Contact ID codes.

• Zone alarm report code (prompt in *56 Zone

Programming) and Trouble report code (*60)

and relevant restore codes (*70, *71) must be

enabled in order for the Configurable Zone Type

codes to be reported.

Programming Installer and User Schedules

The system provides up to 8 schedules, which can be used to control 12 types of system events at pre-

defined times. 4 schedules are intended for use by the end-user, and 4 are reserved for the installer. In

addition, some events are also reserved for the installer only (listed in the “Enter Event” prompt

paragraph below).

NOTES: • The master code can only access schedules 01-04 and events 00-08.

• System clock must be set before programming schedules.

• Programmed schedules do not take effect until the next scheduled “start” time. (e.g., if

programming a schedule time window for 8AM to 5PM, the schedule does not take effect

until 8AM after the schedule has been programmed.)

Start Scheduling mode by entering installer code + [#] + [6] [4] while in normal operating mode.

The following prompts are displayed:

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 111 112

Comments to this Manuals

No comments

ADEMCO Symphony 8142 Setup Guide Page 79

Comments to this Manuals

Related products and manuals for Numeric keypads ADEMCO Symphony 8142