ADEMCO Symphony 8142 Setup Guide download pdf (Page 74)

Installation and Setup Guide

5-18

Zone List Programming

Zone List programming involves:

1. Selecting an appropriate zone list number;

2. Adding the desired zone numbers to be included in that list.

Start Zone List Program Mode by pressing ✱

while in Data Programming mode. The following

prompts are displayed

*81 Menu Mode

PROMPT

VALID ENTRIES EXPLANATION

Zone List No.

(00 = Quit) 01

Zone List Number

01-12 = zone list number

[∗] to continue

Enter the Zone List Number to program (or 00 to

end these entries). Press [

∗

] to advance.

In the following displays, zone list 01 has been

selected for programming.

01 Enter Zn Num.

(00 = Quit) 00

Zone Number

01-06, 9-24, 49-64 = zone

numbers followed by [∗] to

accept each zone

00 to continue

Enter each zone number to add to the zone list,

followed by pressing [

∗

] (example, 01

∗

, 02

∗

, 03

∗

After all zones are entered, press 00 to continue.

IMPORTANT: Do not include fire zones in zone

lists that are used to STOP device actions.

01 Del Zn List?

0 = No 1 = Yes 0

Deleting Zone Lists

0 = don’t delete list

1 = delete this zone list

[∗] to continue

To delete the zone list, enter 1. All zones in the

zone list will be deleted automatically and the

system returns to the Zone List No. prompt.

To save the zone list, enter 0.

01 Delete Zone?

0 = No 1 = Yes 0

Deleting a Zone

0 = don’t delete zones

1 = go to next prompt to delete

zones

[∗] to continue

To save the entire zone list, enter 0 and the

system returns to the Zone List No. prompt.

To delete a zone or zones in a zone list enter 1 to

continue.

01 Zn to Delete?

(00 = Quit) 00

Delete the Zone

01-06, 9-24, 49-64 zones to be

deleted from list followed

by [∗] to accept each zone

00 to continue

Enter each zone to be deleted from the list,

followed by [

∗

]. After all zones to be deleted are

entered, enter 00 to return to the Zone List No.

prompt. so that another list can be programmed, if

desired.

Notes:

• Any list may include any or all of the system's zone numbers.

• A zone list can be assigned to more than one output relay.

• When creating zone list 4 for linked zones, include only zones assigned to zone types 3, 4, or 5. Do not

include zones that have delays (entry/exit zones, interior w/delay) or 24-hour zones, as these zone types

may produce unpredictable operation and may not function as intended.

About Function Key Programming (∗

∗∗

∗57 Menu Mode)

The system provides the ability to program each of the four keypad function keys to perform one of 12

system operations. The end user can then activate the function by simply pressing and holding the

programmed key for 2 seconds. Typical functions (listed below) include single-button arming, turning

lights on/off, or single-button paging.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 111 112

Comments to this Manuals

No comments

ADEMCO Symphony 8142 Setup Guide Page 74

Comments to this Manuals

Related products and manuals for Numeric keypads ADEMCO Symphony 8142