ADEMCO VISTA 10 Setup Guide download pdf (Page 21)

3-1

SECTION 3

Programming Overview

•••••••••••••••••••••••••••••••••••••••••••••••••

About Programming

You can program the system at any time, even at the installer's premises prior to the actual installation. Programming

can also be performed remotely from the installer’s office/home, using an IBM personal computer, a modem, and

Compass downloading software.

The following is a list of the various Programming modes used to program this system:

Programming Mode…

Used to …

Data Field Programming

Program basic data fields used for setting the various system options. Some of

the data fields in this system have been programmed by default for specific

values. However, other fields must be programmed for each particular

installation to establish its specific alarm and reporting features.

✱

56 Zone Programming

Assign zone characteristics, report codes, alpha descriptors, and serial numbers

for 5800 RF transmitters in step-by-step procedural form.

✱

58 Expert Mode Programming

Assign zone attributes similar to

∗

56 mode, while providing a faster

programming procedure and is intended for use by those more experienced in

programming controls of this type.

✱

80 Output Relay Programming

Program the 4204 Relay Module that contains 4 relays

✱

81 Zone List Programming

Program zone lists for relay control

✱

82 Alpha Programming

Create alpha descriptors for easy zone identification.

Zone Response Type Definitions

You must assign a zone type to each zone, which defines the way in which the system responds to faults in that zone.

Zone types are defined below.

Zone Type Description/Characteristics

Type 00

Zone Not Used

Program a zone with this zone type if the zone is not used.

Type 01

Entry/Exit

Burglary

Zone type 01 is usually assigned to sensors or contacts on primary entry and exit doors.

•

Entry delay #1 is programmable from 0-99 seconds (field

35).

•

Exit delay is independently programmable from 0-99 seconds (field

34).

•

Exit and entry delays when armed in AWAY or STAY mode.

•

No entry delay when armed in INSTANT or MAXIMUM mode.

•

Exit delay regardless of the arming mode selected

Type 02

This zone type is not used.

Type 03

Perimeter

Burglary

Zone type 03 is usually assigned to all sensors or contacts on exterior doors and windows.

•

Instant alarm when armed in AWAY, STAY, INSTANT, or MAXIMUM mode.

Type 04

Interior

Follower

Zone type 04 is usually assigned to a zone covering an entry area (i.e.: foyer, lobby, or

hallway) that one must pass upon entry (after faulting the entry/exit zone) to reach the

keypad. It provides an instant alarm if the entry/exit zone is not violated first, and protects

an area in the event an intruder has hidden on the premises before the system is armed, or

gains access to the premises through an unprotected area.

•

Delayed alarm (using the programmed entry/exit time) if entry/exit (type 01) or interior-

with-delay (type 10) zone is faulted first.

•

Instant alarm in all other situations.

•

Active when armed in AWAY or MAXIMUM mode.

•

Bypassed automatically when armed in STAY or INSTANT mode.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 79 80

Comments to this Manuals

No comments

ADEMCO VISTA 10 Setup Guide Page 21

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA 10