ADEMCO VISTA 10 Setup Guide download pdf (Page 52)

VISTA-10SE Installation and Setup Guide

8-2

PROMPT

PROCEDURE

Default Descriptor

↓

✱

ZN 01 ZONE 01

If a descriptor was

not

entered previously for zone 01, the default descriptor for zone 01 will be

displayed.

Note that no entries can be made. Entries can be made only when the display contains a flashing cursor,

which signifies the “entry mode.”

Flashing Cursor (system is

ready for entry of word).

↓

✱

ZN 01 A

6. To delete or change the default descriptor for zone 1,

press

[

✱

]

plus the same zone number

(01).

This will clear that descriptor and gain access to the entry mode with flashing cursor,

allowing changes to be made.

NOTE:

If you do not wish to change the existing descriptor for zone 01, enter [

✱

]

plus the next zone

number for which you wish to enter (or check) a descriptor. A summary display for that zone will

appear. You must then press [

✱

]

plus the same zone number again to gain access to the entry mode

(flashing cursor) for that zone.

Flashing Cursor

↓

✱

ZN 01

B ACK

Press

[#]

plus a 3-digit number

for the first word from the ALPHA VOCABULARY LIST on a

following page.

Example:

The descriptor that we wish to enter for zone 01 is BACK DOOR. From

the LIST, BACK = 013.

Therefore, we enter

# 0 1 3

NOTE:

If you accidentally enter the wrong word, simply press [#] plus the correct 3-digit

number for the word you want.

✱

ZN 01 B

ACK

↑

Flashing Cursor if [6] is

pressed (system is ready

for next word).

Press [6] to accept the first word and continue.

NOTE:

this

is the only word you are using for the descriptor, press [

] instead of [

] to save that

word in memory, and then go to step 12.

✱

ZN 01 B

ACK

D OOR

↑

Flashing Cursor

Enter the 3-digit number for the next word.

In our example, the word is DOOR, whose

number is “057.”

10. Enter

# 0 5 7

. The display at left appears.

✱

ZN 01 B

ACK

DOOR A

↑

Flashing Cursor if [6] is

pressed (system is ready

for next word).

11. Press

[6] to

the first two words.

NOTE:

If these are the only words you are using for the descriptor, press [8] instead of [6] to save

them in memory.

12. The two words in our example have now been entered. Note however, that up to three words may

be entered (provided the number of characters will fit on the screen).

Press [8]

to save all words

in memory.

✱

ZN 01 BACK

DOOR

The “A” with the flashing cursor disappears, indicating that the word(s) are stored in memory for

that zone, as shown in the display at the left. To exit this mode, skip to step 13.

13. To enter a descriptor for the next zone, press [

✱

] plus the desired zone number (e.g.,

✱

02. The

display following step 5 appears. Repeat steps 6 through 11 to enter the descriptor for the next

zone.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 79 80

Comments to this Manuals

No comments

ADEMCO VISTA 10 Setup Guide Page 52

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA 10