ADEMCO VISTA 10 Setup Guide download pdf (Page 53)

Section 8 – Alpha Descriptor Programming

8-3

PROMPT

PROCEDURE

Program Alpha?

0 = No, 1 = Yes 0

14. Enter

✱

. The “Program Alpha?” prompt at left appears.

Press 0 (No). The Alpha Pgm prompt appears.

Press [

✱

] to continue

Alpha Pgm

15.

Press [

✱

] to continue exiting and to program another field.

16. Enter

✱

to exit the Programming mode.

Adding Custom Words

You can add up to five installer-defined words to the built-in vocabulary. Each of the five "words" can actually consist of

a "word string" of one or more words, but no more than a total of ten characters (including spaces) can be used for each

word or word string.

Custom Words will not be annunciated by a 4285 or 4286 VIP Module.

Custom words must begin with an

alphabetic

character. If a number or symbol is used as the

first character, the word will

not

be saved.

PROMPT

PROCEDURE

Perform the first three steps of

Programming Zone Descriptors

on a previous page.

Custom Words ?

0 = No 1 = Yes

1. Enter 1 (Yes) when the prompt at left is displayed.

Custom words are found as numbers 250-254 on the Alpha Vocabulary List.

2. At the Custom? Prompt, enter the number (1–5) of the custom word or word string to be created

(for example, if you are creating the

first

custom word or word-string, enter 1; for the

second

custom word

, enter 2, etc.). A flashing cursor will now appear at the beginning of the second line

on the display.

Custom 1

↑

Flashing Cursor

To enter the custom word' characters,

refer to the CHARACTER (ASCI) CHART of letters,

numbers, and symbols on a following page

Press the [#] key, followed by the two-digit entry for the first letter you would like to display

(for

example, if you want to enter OLD SHED as the custom words, press #79 for "O," press # 76 for

"L," etc.).

4. When you have displayed the desired character, press [6] to select it. The cursor will then move one

position to the right, ready for the next character.

Press the [6] key again to make a space between characters.

Custom 1

OLD SHED

5. Repeat steps 3 and 4 to create the desired word(s). Note that the [4] key can be used to move the

cursor to the left.

Remember, no word or word-string can exceed 10 characters including spaces.

Custom ?

6. Press the [8] key to save the custom word(s) and select another Custom Word. The custom word(s)

you entered will automatically be added to the built-in vocabulary.

For the above example, the key strokes would be: #79, 6, #76, 6, #68, 6, 6, #83, 6, #72, 6, #69, 6, #68,

6, 8.

Repeat steps 2–6 for the next custom words to be entered. To change a custom word, just overwrite

it.

7. If no more custom words are to be entered now, press [0] to return to the Program Alpha? prompt.

Then press 0 (No). The Alpha Pgm-82 prompt appears. To advance to the next field, press

✱

and

the desired field.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 79 80

Comments to this Manuals

No comments

ADEMCO VISTA 10 Setup Guide Page 53

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA 10