ADEMCO VISTA 10 Setup Guide download pdf (Page 35)

5–1

SECTION 5

Zone Programming

(

✱

56 and

✱

58 Menu Mode)

•••••••••••••••••••••••••••••••••••••••••••••••••

About Zone Programming

Programming Wireless Zones

5800 Series transmitters have built-in serial numbers that must be enrolled into the system using the

✱

56 or

✱

58 programming modes in this section, or input to the control via the downloader.

Some transmitters, such as the 5816 and 5817, can support more than one “zone” (referred to as loops or

inputs). Refer to the 5800 Series Transmitter Input Loop Identification paragraph on a following page.

Each loop must be assigned a different zone number.

✱

56 Zone Programming (Interactive Menu) is used to program zones, zone types, report codes, enroll 5800

RF Wireless Transmitter serial numbers, and identify the type of loop input device(s). This mode can also be

used to enter alpha descriptors for programmed zones; however, we recommend entering descriptors in

menu mode

✱

82 (Alpha Descriptor Programming) after all zone programming is completed.

For a faster method of zone programming, you can use the

✱

58 Expert Programming Mode instead of

✱

Zone programming. The

✱

58 Expert Programming Mode (Interactive Menu) is designed for those who have

had previous experience in programming control panels of this type.

NOTE: Alpha display prompts are shown in a double-line box.

✱

56 Zone Programming Procedure

Zone Programming involves:

Entering the programming mode by pressing

✱

Pressing

✱

22 (RF System) to enable reception of 5800 series transmitters

Pressing

✱

56 to start zone programming

Making appropriate entries at the prompts

Confirming the serial number of wireless transmitter zones.

The following prompts are displayed:

PROMPT VALID ENTRIES EXPLANATION

SET TO CONFIRM?

0 = NO 1 = YES 0

Set to Confirm

0 = no

1 = yes

This display appears upon entry into

✱

56 mode. The default is

(No). If you enter

(Yes), you are prompted to confirm each

transmitter after entering the serial and loop numbers (at the

XMIT TO CONFIRM

prompt later in this procedure).

We recommend that you confirm the programming of every

transmitter.

Enter Zn Num.

(00 = Quit) 10

Zone 10 entered

↑

Zone Number

1-25, 7, 95, 96

00 = quit

[

✱

]

to continue.

Zone Number (ZN):

Enter the zone number that you wish to

program.

Zones 7, 95, or 96 may be entered (these are all emergency (panic)

key zones.

Zone 10 has been entered as an example in display at left.

Zn ZT – RC In: L

10 00 – 10 RF: –

Summary Screen

[

✱

] to continue.

summary display

appears, showing the status of that zone’s

programming when using wireless keys.

NOTE:

If you are programming hardwired zones 01

06, the display

appears as follows.

ZN ZT – RC IN: L

02 00 – 10 HW: –

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 79 80

Comments to this Manuals

No comments

ADEMCO VISTA 10 Setup Guide Page 35

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA 10