ADEMCO Vista-128FB Setup Guide download pdf (Page 75)

5-1

SECTION 5

Data Field Descriptions

••••••••••••••••••••••••••••••••••••••••••••••••

•

About Data Field Programming

The following pages list this control’s data fields in numerical order. Field numbers are listed in the left column,

followed by a “Title and Data Entries column, which lists the valid entries for each field. Experienced installers can

simply follow this column when programming the data fields. The “Explanation” column provides explanatory

information and special notes where applicable.

NOTE: Refer to the Programming Guide for the default values. They are not listed in this section.

Use the

Programming Guide

to record the data for this installation.

NOTE: All references in this manual for number of zones, number of user codes, number of access cards,

and the event log capacity, use the VISTA-250BP’s features. See SECTION 1: General Description for the

table listing the differences between the VISTA-128BP and the VISTA-250BP control panels. All other

features are identical, except for the Remote Keypad Sounder (field 1✴46 option 2), which is available only

in the VISTA128BP.

Programming Data Fields

Data field programming involves making the appropriate entries for each of the data fields. Start Data Field

programming by entering the installer code + 8 + 0 + 0 + 0.

FIELD

TITLE and DATA ENTRIES EXPLANATION

*00

Installer Code

Enter 4 digits, 0-9

The Installer Code is a 4-digit code reserved for installation company use.

This is the only code that can be used to enter the Program Mode from the

keypad. This code cannot be used to disarm the system if it isn’t used to arm

the system. This code cannot be used to re-enter Program Mode if Program

Mode is exited by the *98 command.

*04

Enable Random Timers For

Partitions 1-8

0 = disable

1 = enable

If enabled, the activation time of the window is randomized up to 30 minutes and

is initialized by either of two methods:

User Code + [#] + [41] Initiates the random schedule for all devices in the

partition.

User Code + [#] + [42] Initiates the random schedule for all devices in the

partition with a time window within 6 PM and 5 AM.

*05

System Events Notify

0 = disable

1 = enable

If enabled the system sends notification messages via the RS232 port. Field *14

must be set for RS232 port (1).

NOTE: If enabled, the system also sends fault and restore messages via the

RS232 port.

Quick Exit (partition-specific)

0 = disable

1 = enable

If enabled, allows users to exit the armed partition without disarming and then

rearming the partition.

Quick Exit is initiated by entering [#] + [9]. This restarts the exit delay. All rules

of exit apply, including exit error logic.

Quick Exit is not permitted for use with the VISTA-128BP/VISTA-250BP Control Panel in a UL installation.

*06

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 146 147

Comments to this Manuals

No comments

ADEMCO Vista-128FB Setup Guide Page 75

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-128FB