ADEMCO VISTA-100 Service Manual download pdf (Page 69)

7830R

AlarmNet-M Transceiver

SPECIFICATIONS:

ORDERING:

The 7830R is wired to the panel per wiring diagram provided

with the radio. Observe the LED once the 7830R is in normal

operating mode to determine optimal installation location via

built in diagnostics of the 7830R. Can be mounted vertically or

horizontally depending on which antenna is used. Radio should

not be mounted where it would be obstructed by a steel

structure such as security doors and windows which may be

pulled down at night. Once the radio has been installed and

tested, it must be registered with AlarmNet before it can be

monitored. NOTE: No alarm traffic will be routed to the

monitoring central station until the 7830R completes the

registration process.

ACCESSORIES

Cables

• 7626-5, 7626-12, 7626-25HC, 7626-50HC

Antennas

• 7625-3DB - 3dB gain antenna

• 7674 - directional antenna (6dB)

• 7674-13-directional antenna (13dB)

• 7825 - weatherproof outdoor antenna

• 7825MB - Mounting bracket for 7825 antenna

• 7825DP - dipole antenna for vertical mounting

Miscellaneous

• 1361 - transformer (required for operation)

• 7720BT- battery (required for operation)

Programmable Features

EEROM (Electrically Erasable ROM) technology allows the

7830R to be programmed via the AlarmNet 7720P

programmer.

Programmable features include

• Daily supervision ON/OFF

• Tamper reporting ON/OFF

• Opening/closing reports ON/OFF

• Telco line fault report ON/OFF

• DC loss report ON/OFF

• Zone delay for each of 4 zones

• Voltage trigger input, inverted or non-inverted

• Dry contact input, normally open or normally closed

• Pulsed or non-pulsed for each zone (alarm trigger from bell

output to differentiate Burg/Fire

• Fault relay ON/OFF

• Fault relay latch ON/OFF

• Dual Central Station reporting

MECHANICAL

Dimensions

• 8.5" x 9.5"'x 1.7" (without antenna or RF connector)

Operating Temp

• -30° to +60° C

Storage Temp

• -40° to +70° C

Humidity

• 5% to 95%, non-condensing

Altitude

• To 10,000' operating

ELECTRICAL

Power

• 16.5VAC 40VA transformer

Battery Backup

• 12V 0,8Ah rechargeable sealed lead acid battery

Current Drain

• 130 mA average

Input Trigger Levels

• Gate "O"' level less than 1.5V, "I" level greater rate than

3.5V, Sense of 4 zones, may be inverted in groups of 2

TRANSMITTER

RF Power Output

• 2 watts maximum

Frequency Stability

• ±1.5 ppm

Frequency Bond

• 896-902 MHz Transmit 935-941 MHz Receive

Channel separation

• 12.5 kHz

Modulation Modified

• Modified GMSK 8kbps data rate

Receiver Sensitivity

• 113 dBm

Regulatory Approvals

• FCC90-UL, ULC

Radio Fault Output

• Form C relay (can be programmed for fail-safe if desired)

Part No. Description

7830R Subscriber Transceiver

7830RCN Subscriber Transceiver (Canada)

Ask your provider for the AlarmNet technology used in your area.

AlarmNet-A Original AlarmNet

AlarmNet-M Mobitex System

AlarmNet-C Control Channel Cellular

AlarmNet-i Internet

AlarmNet Services

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 79 80

Comments to this Manuals

No comments

ADEMCO VISTA-100 Service Manual Page 69

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA-100