ADEMCO Accord Installation Manual download pdf (Page 18)

Connecting Keypads, Sounders and a Speaker to the Accord XPC

Mounting and Wiring the LED Remote Keypad

1. Press down the two base clips recessed

on top of the keypad while gently pulling

the two halves of the case apart.

2. Route the wiring from the Control Panel

through the Cable Entry Hole on the back

case. Use Knockout Holes A or B if

alternative routes are necessary.

Tip: Use

a knife to help dislodge knockouts

3. Securely mount the back case to a wall or

electrical box via the mounting holes.

Ensure The Tamper Tab is securely

screwed down.

4. The remote keypad PCB should be wired

to the control panel PCB as outlined in Table

2.1 LED/Icon Keypad Wiring.

5. Re-attach the keypad front to the back case by inserting the hinges on the keypad front into

the hinge retainers on the bottom of the keypad back case. Gently apply pressure to the

keypad front until the two retaining tabs click firmly into place.

Fig 2.3 Accord xpC LED Keypad

Mounting and Wiring the Icon Remote Keypad

To mount and wire the Accord xpC Icon keypad:

1. Loosen the retained fastening screw on the bottom

of the keypad. Gently pull the front and back

keypad casing apart.

2. Route the wiring from the control panel through

any of the five knockout holes on the back case

of the keypad.

Tip: Use a knife to help dislodge

knockouts.

3. Securely mount the back case to a wall or

electrical box via the mounting holes. Ensure The

Tamper Tab is securely screwed down.

4. The remote keypad PCB should be wired to the

control panel PCB as outlined in Table 2.1 LED/

Icon Keypad Wiring.

5. Re-attach the keypad front to the back case,

aligning the hinges on the top. Gently apply

pressure to the keypad front and tighten the

retained fastening screw on the bottom.

KnocKnockoutout

Fig 2.4 Accord xpC Icon Keypad

lenaPdapyeK

+XUAev+

–XUAev–

OD/DAP'Kdapk

Table 2.1 LED/Icon Keypad Wiring

Note: Up to four keypads can be connected to the

system. Keypads can be wired to the control

panel independently, in series, or in a star

configuration. Both LED and Icon keypads

can be connected to the same panel.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 77 78

Comments to this Manuals

No comments

ADEMCO Accord Installation Manual Page 18

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Accord