ADEMCO Accord Installation Manual Page 78
- Page / 78
- Table of contents
- BOOKMARKS
- Installation Manual 1
- Contents 3
- Safety Compliance 9
- Mains Supply Connections 10
- Telecoms Approvals 11
- Zone Cable Type 12
- Equipment Electrical Rating 13
- Ancillaries Pack 15
- Initial Mounting 15
- SW1 — Accord Tamper 16
- To remove the PCB: 16
- To replace the PCB: 16
- Tip: Use 18
- ALARM TAMP 19
- XPC to the PSTN 20
- Final Mounting 22
- Testing the Installation 23
- Table 3.1 Programming Groups 26
- Part and Night Set) 27
- Table 3.4 Night Set Zones 28
- Programming System Options 30
- Table 3.7 Bell Cut-off Times 31
- 0. Set (on in any set state) 32
- Table 3.12 No of Rings 38
- 0 = Comms Disabled 39
- 1 = High Speed (8 channel) 39
- 2 = Contact I.D 39
- 1 Before Entry 40
- 2 Except Entry 40
- 3 Always 40
- 1 Always disable 42
- 2 Full set only 42
- 3 During Entry 42
- 0 Single Report 43
- 1 Dual Report 43
- Table 3.14 Group 8—Triggers 47
- Table 3.16 System Parameters 49
- Zone Type Definitions 54
- Instructions 57
- Wire Free Programming 58
- From programming mode: 59
- Site Surveying 61
- Walk Test 61
- Reprogramming Your Code 65
- Programming New User Codes 66
- Printing the Event Log 67
- What they Mean 69
- Appendix A: Specifications 71
- Physical Width: 120 mm 72
- Height: 120 mm 72
- Depth: 25 mm 72
- PROGRAMMING FORM 74
- IP1-1232 Issue 4 75
- Redditch, B98 9HE 76
- IE1-1232 Issue 3 78
Related products and manuals for Security access control systems ADEMCO Accord
(8 pages)
(56 pages)© 2020, manymanuals.com. All rights reserved. | 0.472 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals