ADEMCO Accord Installation Manual download pdf (Page 59)

4. Exit programming mode and walk test the detectors to determine the best

location for each, and for the receiver/keypad.

* Note: Most detectors should be programmed as loop 1. The 5816H has two loops. If

using the built in reed switch, program the zone for loop 2. Loop 1 on this device

corresponds to the Normally closed contact terminals. The tamper terminals (left hand

pair) should always be linked out when not used.

Deleting a wire free zone

From programming mode:

1. Press #1 to access the wire free programming group.

2. Press the number of the zone to be deleted.

3. Enter 0 for the supervision option and 0 for the loop number.

4. A double beep confirms the zone has been deleted.

Adding Keyfobs for setting/unsetting

The 5804 keyfobs can be used with the Accord xpC to set and unset the system. They

will not reset an alarm condition. They can be programmed in two modes, Standard,

and High Security. Each time the keyfob is used, it transmits a coded serial number to

the panel to identify it. In high security mode, this number changes each time it is

used, so that it is impossible to copy.

Please note that before keyfobs can be used they must be enabled in programming

mode Group 0 option 4. Set this option to 0 or 1 to enable Keyfobs for normal opera-

tion. The default is disabled.

Standard Mode

From Day mode:

1. Enter code, 8, user number.

2. Wait for double beep.

3. If receiver is 5882 press and hold all four keys on the fob until a double beep is

heard then release the keys.

4. If receiver is 6128 press and hold any three keys on the fob until a double beep

is heard then release the keys.

5. Press and hold any single key on fob until a double beep is heard.

If at any time a triple beep is heard, the learn procedure has failed. Wait 10 seconds

and retry from #1.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 77 78

No comments

ADEMCO Accord Installation Manual Page 59