ADEMCO Accord Installation Manual download pdf (Page 49)

System Programming — Group 9 Parameters

SNOITPOMETSYS

PUORGNOITPOTLUAFED

9.)seY=1,oN=0(senoZdettimOetacinummoC=1)0(

9.)seY=1,oN=0(langisteS/tesnUtrevnI=2)0(

9.)rebmunenoz=8–1,enoN=0(enozkconKelbuoD=3)0(

9.)seY=1,oN=0(timOenoZresU=4)1(

9.)seY=1,oN=0(teseR/tesnUnoslangiserotserdneS=5)0(

9.)seY=1,oN=0(dewollanoitaivedyrtnE=6)1(

9.)seY=1,oN=0(goltnevetnirP=7)0(

9)seY=1,oN=0(sgnittestluafedyrotcaF=8)0(

9.)seY=1,oN=0(noisreverawtfosweiV=9)0(

Table 3.16 System Parameters

Group 9 — Option 1 Communicate Omitted Zones

When choosing Contact I.D. as a communication format, zones can be omitted to

prevent them operating in this mode. This option allows these zones to communicate

with the central station.

This option has two settings:

0. No (Communicate omitted zones disabled)

1. Yes (Communicate omitted zones enabled)

This option defaults to 0 (Communicate omitted zones disabled).

Group 9 — Option 2 Invert Open/Close Signals

This option has two settings:

0. No (invert Open/Close disabled).

1. Yes (invert Open/Close enabled).

This option defaults to 0 (invert Open/Close disabled).

If this option is enabled (1), Set signals report a Code 4 signal on Channel 4. If

disabled (2), Unset signals report a Code 2 signal on Channel 4.

Group 9 — Option 3 Double Knock Zone

This option allows one zone to be programmed as a Double Knock zone. The control

panel will only acknowledge the Double Knock zone if it is activated twice within five

minutes, or once for more than ten seconds.

Note: Only one zone can be selected for double knock. If a zone is programmed as

Double Knock, unsetting and setting will not affect the Double Knock status.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 77 78

No comments

ADEMCO Accord Installation Manual Page 49