ADEMCO Accord Installation Manual download pdf (Page 66)

Note: The master user code defaults to 1234, the Engineer Code defaults to 9090.

The master user code can reprogramme the other seven user codes. Only the master

user code can be used to reprogramme the master user code.

Only the Engineer code can be used to reprogramme the Engineer Code.

Each user can reprogramme their own code.

Programming New User Codes

To programme a new User Code, enter the Master User Code, select the code option

by pressing 8, press the appropriate key to select the User Code (2 — 8) and enter the

new code number.

Example: To programme User Code 2 as 2626:

• Enter the Master User Code.

• Press: 8 2 2626.

• Two beeps confirm that the new code has been accepted.

• User Code 2 is now 2626.

Removing a User Code from the System

Users can remove their own user code from the system. To remove their own User

Code, enter code, select the codes option by pressing 8, press the appropriate key for

your user number and press the Ö key.

Example: To delete User Code 2 from the system User 2 should:

• Enter user 2’s User Code.

• Press: 8 2 Ö.

• Two beeps confirm that the User Code has been deleted.

• User two has been removed from the system.

Note: The Master User Code (User 1) can delete the other seven User Codes. The

Master User Code cannot be deleted. If the engineer deletes the engineer code,

it can be rectified by defaulting the code.

Enabling/Disabling the Chime Function 9 ( )

Any zone can be programmed to Chime (two beeps from the keypad and internal

sounder) when it is activated.

Enabling the Chime Function on Zones

To enable the Chime function on a zone or zones: enter your User Code, select the

Chime option by pressing 9 and press the appropriate keys for the zones you wish to

chime.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 77 78

No comments

ADEMCO Accord Installation Manual Page 66