ADEMCO VISTA-250FBP Setup Guide download pdf (Page 56)

VISTA-128FBP/VISTA-250FBP Installation and Setup Guide

4-2

In either of the above cases, simply re-enter [✳] + the

correct field number and then enter the correct data.

Programming System-Wide Data Fields

Values for some programming fields are system-wide

(global), and some can be different for each partition

(partition-specific).

The partition-specific programming fields are

automatically skipped when programming the

global fields. If the system has only 1 partition,

the partition-specific fields

are not

automaticall

skipped.

To program system-wide data fields, perform the

following steps:

Step Action

1 Enter Program Mode: Installer Code + 8 0 0 0.

The following display appears:

Program Mode

✳Fill # View – 00

2 If the control has not been programmed before,

enter ✳97 to load factory defaults.

3 Press [✳] and enter the first field number to be

programmed (for example, ✳00, Installers

Code). Make the desired entry. When the field

is complete, the keypad beeps three times and

advances to the next field. If you do not want to

change the next field, press [✳] and enter the

next field number to be programmed.

First Page of fields

(✳00 - ✳90)

To move to the next page of fields, press ✳94.

To return to the previous page, press ✳99.

4 Press ✳99 or ✳98 to exit Program Mode.

NOTE: If the number of digits that you enter in a data

field is fewer than the maximum permitted (for

example, a phone number), the keypad displays the last

entry and waits. To proceed, enter [✳] + the next data

field you wish to program.

Programming Partition-Specific Data Fields

To program partition-specific data fields once in

Program Mode, do the following:

Step Action

1 Enter Program Mode: Installer Code + 8 0 0

2 Press ✳91, which will prompt you for the

partition number desired.

3 Enter a partition-specific field number (e.g.,

✳09) to begin programming.

When the first field’s entry is completed, the

next partition-specific field is automatically

displayed. When all partition-specific fields

are programmed, the system returns to the

global programming fields (page 1 fields).

4 Repeat this procedure for each partition in

the installation.

NOTE: To return to the global program fields before

finishing all fields, enter any global field number.

Programming Partition-Specific Fields

Press ✳91 to select a partition.

↓

↓↓

↓

Enter the partition to be programmed.

↓

↓↓

↓

Enter a partition-specific field number and make entry.

↓

↓↓

↓

After partition-specific fields are programmed,

press ✳91 to select next partition.

Enter any global field number to return to the global

fields at any time.

#93 Menu Mode Programming

The #93 Menu Mode is an interactive mode through

which much of the system’s programming is done. In

this mode, there are “question and answer” prompts

that can be accessed once Data Field Program Mode has

been entered. These prompts require a 2-line alpha

keypad (6160/6160CR-2).

After programming all system-related programming

fields in the usual way, press #93 while still in

programming mode to display the first choice of the

menu-driven programming functions. Press 0 (NO) or 1

(YES) in response to the displayed menu selection.

Pressing 0 will display the next choice in sequence.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 135 136

Comments to this Manuals

No comments

ADEMCO VISTA-250FBP Setup Guide Page 56

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA-250FBP