Section 4 – Programming
4-3
Below are the main menu selections. For details refer to the VISTA-128FBP/VISTA-250FBP Programming Guide.
MAIN MENU
OPTIONS
ZONE PROG?
1 = YES 0 = NO 0
For programming the following:
• Zone Number
• Zone Response Type
• Partition Number for Zone
• Dialer report code for zone
• Input Device Type for zone (whether RF, polling loop, etc.)
• Enrolling serial numbers of 5800 Series transmitters and serial polling loop devices into the system.
• Zone Attributes (e.g., Arm w/Fault, Silent, etc.).
EXPERT MODE?
1 = YES 0 = NO 0
Same as Zone Programming except:
• Done with a minimum number of keystrokes.
• Can program wireless keys using pre-defined templates.
NOTE: All the zone attributes cannot be programmed using the Expert Mode.
REPORT CODE PROG?
1 = YES 0 = NO 0
For programming the following:
• Alarm report codes for zones
• Restore and supervisory codes
• All other system report codes
ALPHA PROG?
1 = YES 0 = NO 0
For entering alpha descriptors for the following:
• Zone Descriptors
• Default Screen
• Custom Words
• Partition Descriptors
DEVICE PROG?
1 = YES 0 = NO 0
For defining the following device characteristics for addressable devices, including keypads, RF receivers
(5881), output relay modules (4204/4204CF), and communication devices (7845i-ent) or (7845i-GSM, and
7845-GSM for Commercial Burg only):
• Device Address
• Device Type
• Keypad Options (including Partition assignment)
• RF House ID
•
Communications device Options (including Programming Communicator)
OUTPUT PGM?
1 = YES 0 = NO 0
For defining output device functions.
RLY VOICE DESCR?
1 = YES 0 = NO 0
Must be set to “0”.
CUSTOM INDEX ?
1 = YES 0 = NO 0
Must be set to “0”.
ACCESS POINT PGM
1 = YES 0 = NO 0
Must be set to “0”.
ACCESS GRP PGM
1 = YES 0 = NO 0
Must be set to “0”.
EVENT/ACTION PGM
1 = YES 0 = NO 0
Must be set to “0”.
Comments to this Manuals