ADEMCO VISTA 10 Setup Guide download pdf (Page 13)

Installing the RF Receiver

You can any ADEMCO 5800 Series Wireless Receivers, including:

RF Receiver No. of Zones

5881L/5882L up to 8

5881M/5882M up to 16 (transmitter zone numbers = 9-24; button zone numbers = 49-56)

5883, 6150RF up to 16 (transmitter zone numbers = 9-24; button zone numbers = 49-56)

1. Set Device Address to “00” as described in its instructions (set all switches to the right, “off” position).

2. Mount the receiver, noting that the RF receiver can detect signals from transmitters within a

nominal range of 200 feet.

3. Connect the receiver's wire harness to the control's keypad terminals. Plug the connector at the

other end of the harness into the receiver. Refer to the installation instructions provided with the

receiver for further installation procedures regarding antenna mounting, etc.

NOTES

• The receiver is supervised and a trouble report is sent (“CHECK 100” displayed) if communication

between the panel and receiver is interrupted, or if no valid RF signals from at least one supervised

transmitter are received within 12 hours.

If the receiver is mounted remotely:

• Place the RF receiver in a high, centrally located area for best reception.

• Do not locate the receiver or transmitters on or near metal objects. This will decrease range and/or

block transmissions.

• Do not locate the RF receiver in an area of high RF interference (indicated by frequent or prolonged

lighting of the LED in the receiver; random flicker is OK).

• Do not locate RF receiver closer than 10 feet from any keypads to avoid interference from the

microprocessors in those units.

MOUNTING

HOLES

INTERFERENCE

INDICATOR

LED

CIRCUIT BOARD

DIP

SWITCH

ANTENNAS

(INSERT IN

RIGHT-HAND

TERMINALS)

YELLOW

RED

BLACK

GREEN

WIRING OPENING

KNOCKOUT AREA

FOR SURFACE WIRING

TO CONTROL'S

REMOTE KEYPAD

CONNECTION

POINTS.

5882

LOCATION

TO RELEASE CIRCUIT BOARD,

REMOVE SCREWS AND

BEND BACK TABS

NOTE

CIRCUIT BOARD IS MOUNTED IN

CONTROL'S CABINET. GROUNDING

LUGS (2) PROVIDED

MUST

BE INSERTED

IN LEFT-HAND TERMINALS OF ANTENNA

BLOCKS AND SECURED TO CABINET.

(SEE RECEIVER'S AND CONTROL'S

INSTRUCTIONS)

SOCKET

PLUG

MODEL NO. IS INDICATED ON CIRCUIT BOARD

5881-003-V0

INSERT IN

RIGHT- HAND

TERMINALS

Figure 9. 5881/5882 RF Receiver (cover removed)

Installing a 5800TM Module

1. Mount the 5800TM next to the RF receiver (between one and two feet from the receiver’s

antennas) using its accompanying mounting bracket. Do not install within the control cabinet.

2. Connect the 5800TM to the control panel’s keypad connection terminals as shown on the

Summary of Connections diagram and set to address 28.

NOTES

• Use this module only if you are using one or more wireless bi-directional keypads or keyfobs with a

wireless Receiver; 5800TM is not necessary if using a Transceiver (e.g., 5883).

• The 5800TM must be set to address 28 (cut red-W1 jumper).

• For additional information regarding the 5800TM, refer to the 5800TM’s instructions.

Mounting and Wiring the Control

2-7

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Comments to this Manuals

No comments

ADEMCO VISTA 10 Setup Guide Page 13

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA 10