ADEMCO VISTA 10 Setup Guide download pdf (Page 50)

Programming Installer and User Schedules

The system provides 2 schedules (one for the installer, one for the end user), which can be used to

control 11 types of system events at pre-defined times.

Start Scheduling mode by entering installer code + [#] + [6] [4] while in normal operating mode.

NOTE: The master code can only access schedules 01 and events 00-07.

PROMPT

VALID ENTRIES and EXPLANATION

ENTER SCHED NO.

00=QUIT 00

Enter the desired schedule number.

01 = end-user schedule; 02 = installer-only schedule; 00 = exit scheduling mode

[∗] to continue

ENTER EVENT

CLEAR EVENT 00

NOTE: Events 07 and 10

cause the keypad to

beep every 30 seconds

when messages are

displayed. Stop the

beeps by pressing any

key.

Enter the desired event number for event you want to occur at a specified time.

Events 10-11 are reserved for the installer only.

00 = clear event

01 = Relay On/Off

02 = User Access

03 = Latch Key Report to Pager (sent to all pagers and is active only when the system is

armed; message sent is 777-7777; user must be enabled for paging; see User Attributes

in System Operation section)

04 = Forced Stay Arming (forced bypass is automatically enabled regardless of setting in

field *23)

05 = Forced Away Arming (forced bypass is automatically enabled regardless of setting in

field *23)

06 = Auto Disarm

07 = Display “Reminder”

10 = Display custom words (system displays custom words 8, 9, and 10 at defined time; can

be used as installer’s reminder message to the end user)

11 = Periodic Test Report (see key commands in Testing the System section to quickly set

periodic test reporting intervals)

[∗] to continue

DEVICE NUMBER

This prompt appears if event “1” (relay on/off) was selected, otherwise it is skipped.

Enter the physical device number as programmed in ∗79 Menu Mode.

01-04 = device number; 17, 18 = built-in triggers 1 and 2 respectively

[∗] to continue to the “Start” prompt

Installation Instructions

5-14

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 71 72

Comments to this Manuals

No comments

ADEMCO VISTA 10 Setup Guide Page 50

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA 10