ADEMCO VISTA 10 Setup Guide download pdf (Page 43)

*80 Menu Mode: Defining Output Functions

Use this mode to program output function definitions (up to 12 functions) that provide automated

control of any of the output devices, based on events occurring on individual zones or zones with

certain zone types.

Each output definition is identified by an output function number, and includes

the following components:

Output Definition Components

Component Description

Output Function No. A reference number that defines an output’s characteristics.

Activated By Determines whether the initiating event occurs on a zone, a zone list, or a zone type.

Event Event that triggers the output action. Can be an event occurring on a specific zone

number or a zone list, or a specific zone type.

Output Action Defines the action of the relay when the defined event occurs. Can close for 2 seconds,

stay closed until reset, continuously pulse (1-second close-open-close-open, etc.), toggle

the device state, or activate for a defined duration (set in data field *177).

Output No. Assigns this function to a specific output number (defined in *79 Menu Mode). This is

the output number that will perform this function upon the triggering event. Note that

each defined function is associated with only one output number. This means that if

more than one output device needs to perform this particular function, you need to

define another output function number with the same attributes, but assign the

appropriate output number. (i.e. output devices can be assigned more than one function

number, but each function number can only be assigned a single output number.

For example, if you want to pulse a strobe light upon fire alarms on zone 4 using a relay mapped to

output number 2 (as programmed in *79 Menu Mode), program the following in *80 Menu Mode:

Prompt Entry

Output Funct. # = 01 (assuming this is the first output function)

Activated By: = 3 (zone number)

Enter Zn No. = 04 (requires 2-digit zone numbers)

Output Action = 3 (continuous pulse)

Output Number = 02 (device mapped in *79 Menu Mode)

Start Output Definition mode by pressing ✱

80 while in Data Programming mode.

∗

∗∗

∗80 Menu Mode

PROMPT

VALID ENTRIES and EXPLANATION

Output Funct. #

(00 = Quit) 01

Enter the output function number to be defined

01-12 = output function number

[∗] to continue; 00 = exit

01 A E Trig

?00 0 0 – ZL=00

This screen displays a summary of the current output programming

A = Output Action; E = Triggering event; Trig = Trigger type

Question mark indicates the device shown has not been mapped. Use *79 Menu mode to

map the device.

[∗] to continue

01 Activated By:

Zone List

Select where the initiating event for this output definition is to occur.

0 = delete (deletes the output function and any previous programming)

Delete? To delete this output definition, press 1.

0 = NO, 1 = YES If you do not want to delete this output,. press 0.

1 = zone list (go to “A” prompt); 2 = zone type (go to “B” prompt); 3 = zone number (go to “C”

prompt)

[∗] to continue

5-7

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 71 72

Comments to this Manuals

No comments

ADEMCO VISTA 10 Setup Guide Page 43

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA 10