ADEMCO VISTA 10 Setup Guide download pdf (Page 25)

SECTION 4

Data Field Programming

••••••••••••••••••••••••••••••••••••

About Data Field Programming

The following pages provide explanations of this control’s data fields and is intended to be used in

conjunction with the Programming Guide. Refer to the Programming Guide for the specific

option choices for each data field.

Use the blank programming form to record the data for this installation.

Programming Data Fields

Data field programming involves making the appropriate entries for each of the data fields.

Start Data Field programming by entering the installer code + 8 + 0 + 0.

SIA Guidelines: Notes in certain data fields give instructions for programming the VISTA-10P for False Alarm

Reduction.

Fields unique to the VISTA-10PSIA are indicated by heavy borders and reverse type for easy

identification.

System Setup Fields

FIELD

TITLE and EXPLANATION

*20

Installer Code

Enter a 4-digit Installer Code. This code can perform all system functions except it cannot disarm the

system unless it is used to arm the system.

*21

Quick Arm Enable

Select whether or not users can press the [#] key in place of entering a security code when arming the

system (e.g., to arm AWAY, press [#] + AWAY). If not selected, users must enter a security code to arm

the system. In either case, the user code is always needed to disarm the system.

*22

RF Jam Option

Select whether or not the system sends an RF jam report if an RF jamming signal is detected.

UL installations must be 1 if wireless devices are used.

*23

Quick (Forced) Bypass

Select whether or not the Quick Bypass command (code +[6] + [#]) is active. Zones bypassed by this

function will be displayed after the bypass is initiated.

UL installations must be 0 (no forced bypass)

*24

RF House ID Code

Enter the RF House ID, which identifies receivers and wireless keypads. If a 5827 or 5827BD Wireless

Keypad or 5804BD Transmitter is being used, a House ID code must be entered, and the keypad set to

the same House ID.

*26

Chime By Zone List 3

Select if you want a list of specific zones to chime when faulted while the system is in Chime mode (use

zone list 3 to assign these zones; see ∗81 Zone List Programming section for details). If not selected,

all entry/exit and perimeter zones will chime when faulted and system is in Chime mode.

*28

Access Code for Phone Module

Enter a 2-digit access code for the 4285/4286 Phone Module, if used. Example: If desired access code is

7∗ , 7 is the first entry, and [#] + 11 (for ∗) is the second entry.

NOTE: A “0” in either digit disables the phone module.

Must be “00” for UL Commercial Burglar Alarm installations.

*29

Long Range Radio Output

Select whether or not all messages programmed to go to the primary telephone line receiver will also be

sent to the connected 7720PLUS, 7820, 7835, or 7845 Radio (sent in Contact ID format). The data line is

supervised as well as certain functions in the radio. If communication is lost or a trouble develops, an

attempt will be made to send a message via both radio and telephone to the central station.

Program the radio for device address 3.

4-1

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 71 72

Comments to this Manuals

No comments

ADEMCO VISTA 10 Setup Guide Page 25

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA 10