ADEMCO VISTA 10 Setup Guide download pdf (Page 35)

Keypad Programming Fields

NOTE: Each keypad must be assigned a unique address. Keypads programmed with the same

address will give unpredictable results.

Address 16 is reserved for keypad 1, which is automatically set with all sounds enabled.

FIELD

TITLE and EXPLANATION

*190

Keypad 2 Device Address 17

Select whether or not this keypad is used, and enter the desired sound option for this keypad.

*191

Keypad 3 Device Address 18

Select whether or not this keypad is used, and enter the desired sound option for this keypad.

*192

Keypad 4 Device Address 19

Select whether or not this keypad is used, and enter the desired sound option for this keypad.

*193

Keypad 5 Device Address 20

Select whether or not this keypad is used, and enter the desired sound option for this keypad.

*194

Keypad 6 Device Address 21

Select whether or not this keypad is used, and enter the desired sound option for this keypad.

*195

Keypad 7 Device Address 22

Select whether or not this keypad is used, and enter the desired sound option for this keypad.

*196

Keypad 8 Device Address 23

Select whether or not this keypad is used, and enter the desired sound option for this keypad.

*197

Exit Time Display Interval

Select whether or not keypads display the exit time remaining after arming the system, with display

updates at the interval selected (i.e. if the exit delay is 30 seconds and “2” is selected in this field, the

keypad display refreshes every 2 seconds, displaying 30, 28, 26, 24, etc.).

An interval greater than “1” may be necessary for some older keypads to allow users time to enter key

presses between display updates.

FIXED-WORD KEYPAD NOTE: If using 2-digit display keypads (e.g. 6150RF), do not use exit times

greater than the 96-second delay option. Using a longer delay time may cause end-user confusion

because 2-digit display keypads cannot display times greater than “99.” If longer exit time is required

by the installation, it is recommended that the Exit Time Display option be disabled (“0”).

*199

ECP Fail Display

Select the 2-digit or 3-digit ECP Fail display, based on the type of keypads being used. The 3-digit

display option displays ECP faults as “1” plus the device address (00-30) of the device causing the fault

(e.g., faults on device 07 display as “107”), and is intended for Alpha keypads and/or 3-digit Fixed-Word

Display keypads.

The 2-digit Fixed-Word Display displays ECP faults for all devices as “91” on 2-digit displays, and

“191” on 3-digit or Alpha keypads. It is intended for 2-digit display keypads (e.g., certain 6128 series

keypads

4-11

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 71 72

Comments to this Manuals

No comments