ADEMCO VISTA 10 Setup Guide download pdf (Page 7)

SECTION 2

Mounting and Wiring the Control

••••••••••••••••••••••••••••••••••••

Cabinet and Lock

1. Mount the control cabinet to a sturdy wall in a clean, dry area, which is not readily accessible to

the general public, using fasteners or anchors (not supplied) with the four cabinet mounting

holes.

2. Remove cabinet door, then remove the lock knockout from the door. Insert the key into the lock.

3. Position the lock in the hole, making certain that the latch will make contact with the latch

bracket when the door is closed. When correctly positioned, push the lock until it is held securely

by its snap tabs.

NOTES

• The cabinet can be closed and secured without a lock by using 2 screws in the cover's edge.

CABINET DOOR

BOTTOM

LOCKED

UNLOCKED

cab_lock_snap-001-V0

ADEMCO

PUSH

SNAP

TAB

SNAP

TAB

PUSH

ON LOCK

UNTIL IT

IS SEATED

SECURELY

STEP 2STEP 1

CHECK

POSITION

Figure 1. Installing the Cabinet Lock

Mounting the PC Board Alone (no RF Receiver)

1. Hang two short mounting clips (provided) on the raised cabinet tabs (see Detail B in Fig. 2).

2. a. Insert the top of the circuit board into the slots at the top of the cabinet. Make sure that the

board rests on the correct row (see Detail A).

b. Swing the base of the board into the mounting clips and secure the board to the cabinet with

the accompanying screws (see Detail B).

NOTES

• Before installing the cabinet's contents, remove the metal cabinet knockouts required for wiring

entry. Do not remove the knockouts after the circuit board has been installed.

CIRCUIT

BOARD

DETAIL B

SIDE VIEW

OF MOUNTING

CLIPS

DETAIL A

SIDE VIEW

OF BOARD

SUPPORTING

SLOTS

CIRCUIT

BOARD

MOUNTING-001-V0

CABINET

Figure 2. Mounting the PC Board

2-1

1 2 3 4 5 6 7 8 9 10 11 12 ... 71 72

Comments to this Manuals

No comments

ADEMCO VISTA 10 Setup Guide Page 7

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO VISTA 10