ADEMCO Vista-20HW Troubleshooting Guide download pdf (Page 25)

Enter the partition to which this zone is

assigned, “l” or “2”. The factory default is

partition 1. Press [*] to continue.

-1 for1~ad[l][2]f0rC. Re~er~oSectio7z15

The report code consists of 2 hexadecimal digits,

each in turn consisting of 2 numerical digits. For

example, for a report code of 3C , enter [0][3]

SYSTEM COMMUNICATION for complete

information on report codes, if necessary.

Enter the desired report code and then press [*I

to continue.

‘1 ~~~~fRj~5e~on.10msec,u~

Enter the desired response time for the zone.

Press [*] ;o continue.

Typicalsummarydisplay

-l Con,ue

A summary display will appear, showing the

data for the zone that was just programmed.

If It M programmed satisfactorily, press [*] to

The next request is to enter Alpha descriptors

for the zones. The entry may be done now (enter

1) or may be done at a later time using X82

interactive mode (enter O).We recommend that

the entry of Alpha descriptors be done using *2

mode.

See Section

14. ALPHA DESCRIPTION

PROGRAMMING for specific procedure

-zoneas.icatedPre.o.slY.

If “0” (no) was entered above, the system will

return to the Enter Zone Number prompt.

Proceed with the programming for the next

Whe~ you have programmed all the hard-wired

zones satisfactorily, exit *56 interactive mode at

the Enter Zn Num. prompt by pressing [01[01*

Then exit the programming mode by keying *99.

Proceed to the check-out procedure that follows.

-25-

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 99 100

No comments

ADEMCO Vista-20HW Troubleshooting Guide Page 25