ADEMCO Vista-20HW Troubleshooting Guide download pdf (Page 84)

100

Security Codes

Installer Code

The installer programs the 4-digit Installer Code initially as part of the

programming procedure. The factory default Installer code is “4-l-l-2”, but

may be changed in field *20.

The Installer code is the only code that can enter programming mode and

also, in normal operation mode, is used to enter the Master code for each

partition, which allows access to the normal fimctions of the system.

See Section 4. MECHANIC’S OF PROGRAMMING for information on exiting

the programming mode via fields *98 or *99.

Master Code

In normal operation mode, the Installer code is used to enter the 4-digit

Master security code for each partition, using the keypad connected to

Partition 1:

To enter the Master code for Partition 1, enter:

Installer Code + [8] + [01] + desired 4-digit Master code for Partition 1

To enter the Master code for Partition 2, enter:

Installer Code + [8] + [02] + desired 4-digit Master code for Partition 2

Secondary User Codes

In normal operation mode, each partition’sMaster securitycode can be

used to assign up to 14 secondary 4-digit security codes for that partition. It

can also be used to remove secondary codes from the system (individually).

To assign (or change) a Secondaqy security code, enter (via partition’s ,

keypad):

Partition’s Master Code + [CODE key]+ User # (03-16)

+ desired Secondary Code

Notes: “

●

The system will emit a single beep when each secondary code has been suc-

cessfully entered.

To delete a Secondary security code, enter (via partition’s keypad):

Partition’s Master Code + [CODE key]+ User # (03-16)

All Master and Secondary security codes permit access to the system for

arming, disarming, etc,

The installer code can disarm the system only ifit was used to arm it.

User code No. 15 is a “babysitter” code, i.e., it can disarm the system only

if it was used to arm it.

User code No. 16 is the Duress code. When this is used to perform any

system operation, a special code is sent to the monitoring station. Instruct

users to be carefi-dnot to use this code for normal usage,

If a secondary code is inadvertently repeated for different users, the lower

user number will take priority.

Opening and closing reports are sent for the Installer code as No. 01, with

the appropriate subscriber number. Each Master code and set of secondary

user codes are sent as Nos. 02, and 03–16 respectively in Contact ID

format (with the appropriate subscriber number); in 4+2, it is l–F, “F” for

anything greater than 15; keyswitch will report as user “O”.

-84-

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 99 100

Comments to this Manuals

No comments

ADEMCO Vista-20HW Troubleshooting Guide Page 84

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-20HW