ADEMCO Vista-20HW Troubleshooting Guide download pdf (Page 42)

100

Programming The Control For Phone Access

With at least one 2-line Alpha keypad (5137AD or 6139) connected to the

Partition 1 keypad terminals on the control, power up the system

temporarily. If you had previously connected the AC transformer to the w

control panel, you need only plug in the transformer (to 120VAC outlet) to

power up the system.

2. Enter the programming mode by keying the following on the Alpha

keypad: Installer code (41 12) + 8 + O + O.

3. Press *28. VOICE MODULE ACCESS CODE.

If using a 4285 VIP module, enter the 2-digit phone access code as

follows: For first digit, enter 1–9; for second digit, enter # +11 for “W, or

# +12 for “#”. Example: if desired access code is 7* , 7 is the first entry,

and # + 11 (for*) is the second entry.

Enter “00” if not using a 4285 module (this is the default).

Note: A “O”in either digit will disable thew Voice Module.

4. Press *5. RING DETECTION COUNT. ril

)

Refer to the chart below and program this field accordingly.

Voice

Answering

Module

Machine Downloading

Field *95 Programming

Yes

No Setfor valueotherthan “O”(1-15).

Thiswillenablethe controlpanelto

answerthephonecall. Otherwise,it

will not be possible to access the

4285module.

Yes Yes

Set for a value higher than the

number of rings for which the

answeringmachineis set. Example:

if machine is set for 4 rings, use a

value of 5 or higher. This is recom-

mended so that the 4285 module

can stillbe accessedif the answering

machine is turned off and does not

answerthephonecall.

Yes

No Yes

Setfor valueotherthan “0” (1-15).

Yes Yes

Yes Enter “15” t.abypass the answering

machine.

5. Zone descriptors should also be programmed, regardless of the type of

keypads in use. If this is not done, the 4285 module will not annunciate a

description of the zone(s) in alarm, trouble, etc. (the 4285 will annunciate

zone numbers only).

You can enter zone descriptors now using interactive mode *82, or later.

See the Section 14. ALPHA DESCRIPTION PROGRAMMING for a

detailed procedure.

6. Exit the programming mode by entering *99.

Perform a preliminary check of the 4285 module, as indicated next.

--42-

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 99 100

Comments to this Manuals

No comments

ADEMCO Vista-20HW Troubleshooting Guide Page 42

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-20HW