ADEMCO Vista-20HW Troubleshooting Guide download pdf (Page 34)

100

Programming Options Defined

The following will help you understand the programming of OUTPUT

DEVICES when using *8O and *81 modes. The options used to start and

stop these devices are described below, followed by the actual screen prompts w

and available entries.

The letter(s) in parentheses after each fiction described below, such as (A)

after ACTION, are those that appear in the various summary displays of

programmed data during programming.

ACTION (A) The “ACTION’ of the device is how the device will respond

when it is activated by the “START” programming. You

may want the device to activate momentarily, to pulse on

and off continuously, or to remain activated until some

other event occurs to stop it. There are four different

choices of actions:

● ACTIVATE for 2 SECONDS and then reset.

“ ACTIVATE and REMAIN ACTIYATED until stopped by

some other event.

“ PULSE ON and OFF until stopped by some other event.

● NOT USED when the device is not used.

START (STT) The “START” programming determines when and under

what conditions the device will be activated. The following

START options are available:

A) 1. EVENT (EV) is the condition (Alarm, Fault, Trouble) that

must occur to a zone or group of zones (zone list) in order to

activate the device. These conditions apply

only when a

zone list is used. The different choices for “EVENT” are

listed below and in the “Programming Output Relays &

Powerline Carrier devices” section that follows.

● ALARM

Relay action begins upon any alarm in

an assigned zone in the zone list.

● FAULT

Relay action begins upon any opening or

short in an assigned zone in the zone

list.

c TROUBLE Relay action begins upon any trouble

condition in an assigned zone in the zone

list.

c NOT USED

Relay action is not dependent upon one

of the above events.

2. ZONE LIST (ZL) is a group of zones to which the

“EVENT” applies in order to activate a particular device.

Note that there are a total of 3 zone lists that can be

programmed in field *81 mode; when the selected EVENT

(Alarm, Fault or Trouble) occurs in any zone in the

selected “Start” ZONE LIST (1, 2, or 3), activation of the

selected device will START.

B) 1. ZONE TYPE/SYSTEM OPERATION (ZT). If a System

Operation, such as

“DISARMING” or “ANY FIRE

ALARM,” is to activate the device, the appropriate choice

would also be entered under the “ZONE TYPE” option.

“ZONE TYPE”

is used independently of the

“EVENT/ZONE LIST” combination.

If a specific “ZONE TYFE” is chosen, any zone of that re-

sponse type going into alarm, trouble, or fault will cause the

device to activate as selected in “ACTION.” If the same .,

“ZONE TYPE” is also chosen for the STOP programming,

any zone of that type that restores will de-activate the

device.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 99 100

Comments to this Manuals

No comments

ADEMCO Vista-20HW Troubleshooting Guide Page 34

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-20HW