ADEMCO Vista-20HW Troubleshooting Guide download pdf (Page 71)

100

Descriptions of System Data Fields

THEBLANKPROGRAMMINGFORMSHOULDBEUSEDTORECORDTHEDATAFORTHISINSTALLATION

Defaults (where applicable) Are Indicated In Text

The following is a table containing a list of all data fields in this control

(presented in numerical order). If you have performed the programming

instructions that were included with the installation of each of the various

peripheral devices covered in previous sections, this table will simply serve as

a reference for all data fields in the system. If you have decided to program

all the data fields in the system at one time (and therefore did not perform

the programming indicated previously in each section), you can use this table

to program all the data fields now.

*2O

*21

*23

*25

*27

*X3

INSTALLER CODE

lJJJ_l

The Installer code is used to enter the 4digit Master security code

for each partition in the normal operation mode, via the keypad

connected to Partition 1. See “Master Code” in Section 20. SYSTEM

OPERATION for procedure.

Enter 4 digits, O-9. Default is 4-1-1-2,

QUICK ARM ENABLE

Partition1

❑

Partition2 ❑

If enabled, the [#] key can be used instead of the security code when

arming the system.

Enter Ofor disabled or 1 for enabled for each partition. Default is O.

FORCED BYPASS FUNCTION Partition1

❑ Partition2 ❑

This feature allows sll faulted zones to be bypassed automatically.

All zones that are bypassed by this fimction will be displayed after

the bypass is initiated. Enter, for each partition:

O= No forced bypass. This is the default.

1 = Allows automatic bypass of all open zones.

Must be “O” for UL installations.

WIRED ZONE EXPANSION

Use this field to select the type of expansion unit being used, as

follows

O= none; 1 = 4219; 2 = 4229; 3 = 4204. Default is O.

POWERLINE CARRIER DEVICE (X-1O)HOUSE ID

❑

Powerline Carrier devices require a House ID. This field identifies

this house ID to the control.

If Powerline Carrier devices are used, they are selected in field * 80.

House ID is entered in following manner:

0= A,1=B,2=C, 3= D,4=E,5=F, 6= G,7=H,8=I,9=J,

#+10= ~#+ll=L, #+12= M,#+ 13= N,#+14=0, #+15=P.

Default is O.

VOICE MODULE PHONE CODE (4285)

The use of a 4285 VIP Module (can be used in Partition 1 only)

requires a 2-digit code.

Enter a 2-digit phone access code as follows: For first digit, enter

any any digit from 1 to 9; for second digit, enter # +11 for “*”, or

# +12 for “#”.

Exomple: If desired access code is 7*, 7 is the first entry, and # + 11

(for *) is the second entry.

Default is “00” (Voice Module disabled). Note: A “O” in either digit

will disable the Voice Module.

-71-

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 99 100

Comments to this Manuals

No comments

ADEMCO Vista-20HW Troubleshooting Guide Page 71

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-20HW