ADEMCO Vista-20HW Troubleshooting Guide download pdf (Page 78)

100

RESTORE

*69

REPORTCODES

(*6=76)

*7O

*71

*72

*73

*74

*75

*76

*8O

*81

*8,2

GROUP RESTORES FOR TROUBLE, BYPASS

❑

EnterO for no (report for ~ restore), or 1 for yes (report after M

zones restored). Default is “O”. Note: “1“ not applicable to Contact

ID reporting.

ALARM RESTORE REPORT CODE, 1st DIGIT

•1

2nd digit is automatically sent as the 2nd digit of the zone alarm

report code programmed in field *56, if expanded or 4+2 reporting is

selected.

TROUBLE RESTORE REPORT CODE

See box on previous page. This is sent when a trouble in a zone is

restored. Field *69 applies.

BYPASS RESTORE REPORT CODE

See box on previous page. This is sent when a zone that has been

bypassed is un-bypassed. Field *69 applies.

AC RESTORE REPORT CODE

Seeboxon previouspage. Reports with Partition 1 Subscriber No.

LOW BAT RESTORE REPORT CODE

Seeboxon previouspage. Reports with Partition 1 Subscriber No.

RF XMTR LOW BAT RESTORE REPORT CODE.

(NOT USED)

TEST RESTORE REPORT CODE

See boxon previouspage. Reports with Partition 1 Subscriber No. A

restore code entered here will cause a restore message to be sent

when Test mode is exited.

OUTPUT DEVICES

This is an interactive menu mode that is applicable only if field *25 is w

programmed for a 4229 or 4204, or if Powerline Carrier devices are to

be used. See Section 7. REL4Y OUTPUTS & POWERLINE CARRIER

DEVICES for a detailed programming procedure. Also refer to the

OUTPUT DEVICE table for *8O in the Programming Form.

ZONE LISTS FOR OUTPUT DEVICES

This is an interactive menu mode that is applicable only if field *25 is

programmed for a 4229, 4204, or if Powerline Carrier devices are

used.

Refer to Section 7. RELAY OUTPUTS & POWERLINE CARRIER

DEVICES for a detailed programming procedure. Also refer to the

ZONE LISTS FOR OUTPUT DEVICES table for *81 in the

Programming Form.

CUSTOM ALPHA EDITING

See Section 14. ALPHA DESCRIPTION PROGRAMMING for

procedure.

DDDELETE RF INPUT IDs. (NOT USED)

EVENT LOG 80% FULL REPORT CODE

(Also see “To PROCRAM SYSTEM STATUS, & RESTORE REPORT

CODES box on a previous page).

If an Event Logging selection is made in field *90, a message can be

sent to the central station receiver when the log is 80% full. If the log

becomes fill, a new message will overwrite the oldest message in the

log.

Note: Aside from the selection made by the installer in field *90, all

control and readout from the log is accomplished via the Downloader

(see field *90).

-76-

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 99 100

Comments to this Manuals

No comments

ADEMCO Vista-20HW Troubleshooting Guide Page 78

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-20HW