ADEMCO Vista-20HW Troubleshooting Guide download pdf (Page 69)

100

General Information

Type 00

Zone Not Used

Type 01

Entry/Exit Burglary #1

Type 02

Entry/Exit Burglary #2

Type 03

Perimeter Burglary

‘&pe 04

Interior, Follower

Type 05

Trouble by Day/

Alarm by Night

You must assign a zone type to each zone, which will then define the way in

which the system will respond to faults in that zone. Zone types are defined

below.

Program a zone with this zone type if the zone is not used.

This zone type provides exit and entry delays whenever the zone is faulted if

the control is armed in the Away or Stay modes. When the panel is armed in

the Instant or Maximum modes, no entry delay is provided. Entry delay #1 is

programmable, but Exit delay is automatically set as follows:

Exit Delay = Entry Delay (that has been programmed) +40 seconds.

Exit delay begins whenever the control is armed, regardless of the arming

mode selected. This zone type is usually assigned to sensors or contacts on

doors through which primary entry and exit will take place.

This zone type provides a secondary entry delay whenever the zone is faulted

if the panel is armed in the Away and Stay modes. When the panel is armed

in the Instant or Maximum modes, no entry delay is provided. Entry and Exit

delays #2 are automatically set as follows:

Entry delay #2= programmed Entry delay #1 +30 seconds.

Exit delay #2 = programmed Entry delay #1 + 40 seconds.

Exit delay #2 begins whenever the control is armed, regardless of the arming

mode selected.

This zone type is usually assigned to. sensors or contacts on doors through

which secondary entry and exit will take place, and where more time might

be needed to get to and from the keypad (typically used for a garage, loading

dock, or basement door).

This zone type gives an instant alarm if the zone is faulted when the panel is

armed in the Away, Stay, Instant or Maximum modes. This zone type is

usually assigned to all sensors or contacts on exterior doors and windows.

This zone type gives a delayed alarm (using the programmed Entry/Exit

time) if the Entry/Exit zone is faulted first. Otherwise this zone type gives an

instant alarm. This zone type is active when the panel is armed in the Away

and Maximum modes. This zone type is bypassed automatically when

the panel is armed in the Stay or Instant modes. This zone type is

usually assigned to a zone covering an area such as a foyer, lobby, or hallway

through which one must pass upon entry (After faulting the entry/exit zone to

reach the keypad to disarm the system.)

Since this zone type is designed to provide an instant alarm if the entry/exit

zone is not violated first, it will protect an area in the event an intruder hides

on the premises prior to the system being armed, or gains access to the

premises through an unprotected area.

This zone type will give an instant alarm if faulted when armed in the Away,

Stay, Instant or Maximum (night) modes. During the disarmed state (day),

the system will provide a latched trouble sounding ffom the keypad (and a

central station report, if desired).

T’his mm type is USUallYassigned to a zone

which contains a foil-protected door or window (such as in a store), or to a

zone covering a “sensitive” area such as a stock room, drug supply room, etc.

This zone type can also be used on a sensor or contact in an area where

immediate notification of an entry is desired.

-69-

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 99 100

Comments to this Manuals

No comments

ADEMCO Vista-20HW Troubleshooting Guide Page 69

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-20HW