ADEMCO Vista-20HW Troubleshooting Guide download pdf (Page 79)

100

*W EVENT LOGGING

❑

The VISTA-20HW system has the ability to record various events in a

history log (48-event capacity). The types of events to be logged can be

selected as indicated below. At any time, the downloader operator can

then upload the log and view or print out all or selected categories of

the log. The log can also be cleared by the downloader operator.

The display/printout at the central station will show the date, time,

event, and description of the occurrences. The time is calculated by an

internal clock at the central station computer. Note that the time for

any events that occur prior to a system power-down or an entry into

the programming mode cannot be calculated by the central station

computer. The time will then appear on the log as “unknown”.

O= None; 1 = Alarm/Alarm Restore; 2 = ‘l?roublal’rouble Restore;

4 = Bypass/Bypass Restore; 8 = Open/Close. The default is “3”.

Example: To select “Alarm/Alarm Restore”, and “Open/Close”, enter

9(1 + 8); to select all, enter #15.

Note: System messages are logged when any non-zero selection is

made.

*9 I OPTION SELECTION

❑

Enter “4” if an Audio Alarm Verification (AAV) unit is connected in the

system (l-3 not used); enter “O”if an AAV unit is not being used.

For UL installations, the AAV option must be disabled (enter

“o”).

*92 PHONE LINE MONITOR ENABLE

O= Notused(default)

1 = Localkeypaddisplayonlywhenphonelineis faulted.

2 = Localkeypaddisplaypluskeypadtroublesoundwhenlineis faulted.

Eachpartitionturns offits owntroublesound.No automatictimeout.

3 = Same as “2” aboveplus DeviceNo. 2 STARTS. If eitherpartitionis

armed,externalsounderactivates.External sounderwill be turned

offby normalbell timeout,orby securitycodeplus OFF from either

partition (it does not have to be the one that was armed).

Device number 2 must either be programmed to be STOPPED in

field *8O or STOPPED by entry of security code + # + 8 + 2.

Ptiition in *8O should be set to “O“for STOP.

NOTE: Option 3 may be used even if a relay unit or Powerline

carrier device is not connected to the control.

*93 ~ER C)I?REPORTS IN ARMED PERIOD

This option can be used to limit the number of messages (alarm& alarm

restore reports) sent to the central station in an armed period. “O”

limits reports to a total of 10; “1” allows an unlimited number of

reports. Default is O.

DOWNLOAD

*W DO~OAD PHONE NUMBER

INFORMATION

Enterup to 12 digits;

(*9.4, *95)

11111111111

0-9. #

+11 for “*”. # + 12 for “#”, # + 13 for a pause. Do not fill unused

spaces. End field by entering*. “Toclear entri~s from field, press *9LM.

*95 RING DETEC~OIN COUNT FOR DOWNLOADING

Enternumberofrings beforecontrolpicksup phoneline(orOor 15).

Refertothe chartthat followsandprogram

this field accordingly.

-79-

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 99 100

Comments to this Manuals

No comments

ADEMCO Vista-20HW Troubleshooting Guide Page 79

Comments to this Manuals

Related products and manuals for Security access control systems ADEMCO Vista-20HW