ADEMCO Vista-20HW Troubleshooting Guide download pdf (Page 57)

When entering Zone ~

Descriptors usin~Method

z, the keypad keys

perform the following

function=

[3]

[1]

[6]

[8]

Scrolls both alphabet

and actual words in

ascending alphabetical

order.

Scrolls both alphabet

and actual words in

descending alphabetical

order.

Selects between alpha-

bet and actualword list;

alsoused to savewords.

Stores the zone descrip-

tionin memory.

SummuryModeDisplay

DefaultDescriptor$

p), ZONEOI ,,

FlashingCursor(systemis

readyforentryof word).

4

+i+ZNOl~

FlashingCursor$

* ZN 01 HACK

II

+f

ZN 01 BACK

❑

A

t

FlashingCursorif “6” is

pressed (systemis ready

for nextword).

++ ZN 01 BACK

El

D OOR

t

FlashingCursor

4.

*

5.

6.

7.

8.

Press “O” (No).* The system will

then automatically display the

descriptor for zone 1.

Theprocedurefor addingcustomwordsto

thebuilt-invocabularywillbe found later

under“AddingCustomWords”.

If a descriptor was not entered

previously for zone 1, the default

descriptor for zone 1 will be dis-

played.

Note that this a “summary mode”,

and that no entries can be made.

Entries can be made only when the

display contains a flashing cursor,

which signifies the “entry mode”.

To delete or change the default

descriptor for zone 1, press * plus

the same zone number (01). This

will clear that descriptor and gain

access to the entry mode with

flashing cursor, allowing changes to

be made.

NOTE: If you do not wish to change

the existing descriptor. for zone 1,

enter * plus the next zone number for

which you wish to enter (or check) a

descriptor. A summary display for

that zone will appear. You must then

press * plus the same zone number

again to gain access to the entry mode

(flashing cursor) for that zone.

Press # plus 3-digit number for the

first word from the

“Alpha

Vocabulary List”. Example: The

descriptor that we wish to enter for

zone 1 is BACK DOOR. From the list,

BACK = 013. Therefore, you would

enter# O 1 3.

Note: If you accidentally enter the

wrong word, simply press # plus the

correct 3-digit number for the word

you want.

Press “6” to accept the selected

word and continue.

Note: If this is the only word you are

using for the descriptor, press “8”

instead of “6” to save that word in

memory, and then go to step 11.

Enter the 3-digit number for the

next word. In our example, the word

is DOOR, whose number is “057”.

Enter # O 5 7. This display will

appear:

-57-

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 99 100

Comments to this Manuals

No comments